Dell VNX5600 VNX Command Line Interface Reference for Block 5.33 - Page 132

VNX CLI for Block 3ffe:80c0:22c:47:: Storage Processor IPv6 Link-local Address: fe80::260:1600:3ce0:151c Storage Processor IPv6 Gateway Address: fe80::20a:8bff:fe5a:967c OUTPUT See the previous page. If the version of VNX OE for Block software running on the SP does not support this command, a Not supported error message is printed to stderr. If the command switches -speed, -auto, -capablespeeds, -requestedspeed, linkstatus, and -all are not supported on the system then an Invalid command line parameters error message is printed to stderr. If IPv6 does not support the system an error is displayed: IPv6 is not supported for this platform. IPv6 is enabled but a value for one of the IPv6 values has not been set so, the value will be displayed as an empty string. networkadmin -mib Configures the SNMP services on the system SP. PREREQUISITES For naviseccli, you must have a user account on the system on which you want to execute the command. DESCRIPTION The naviseccli networkadmin command with the -mib function enables or disables the processing of SNMP MIB read requests on an SP and sets the SNMP community string. This command with no option lists the current status of the SNMP service. Note: To discover current settings, use the networkadmin command with the -mib function. SYNTAX networkadmin -mib [-enable] [-disable] [-community string] [-o] OPTIONS -enable Enables the SNMP services. -disable Disables the SNMP services. -community newstring Sets the SNMP community string to newstring. Note: The -community switch is supported only with ManagementServer release 28 or later. -o Executes the command without prompting for confirmation. 132 EMC® VNX® Series Command Line Interface Reference for Block