Dell VNX5600 VNX Command Line Interface Reference for Block 5.33 - Page 15
Preface
View all Dell VNX5600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Preface As part of an effort to improve and enhance the performance and capabilities of its product lines, revisions of product hardware and software are periodically released. Therefore, some functions described in this document may not be supported by all versions of the software or hardware currently in use. For the most up-to-date information on product features, refer to your product release notes. If a product does not function properly or does not function as described in this document, please contact your Customer Support representative. Audience This guide is part of the EMC VNX documentation set, and is intended for use by those who will use CLI commands to configure, manage, or obtain the status of EMC systems. This version of the manual covers up to VNX systems running release 1.3 of Unisphere. Readers of this guide are expected to be familiar with the following topics: l The operating system running on the servers you will manage. l System components and configurations. For introductory information, refer to the appropriate configuration planning guide for your system. Special notice conventions used in this document DANGER Indicates a hazardous situation which, if not avoided, will result in death or serious injury. WARNING Indicates a hazardous situation which, if not avoided, could result in death or serious injury. CAUTION Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. NOTICE Addresses practices not related to personal injury. Note: Presents information that is important, but not hazard-related. Systems no longer covered in this document The table below lists the systems that are no longer covered in this document and the last revision of this document that included the systems. System removed Last revision including the system CX200, CX400, and CX600 300-003-628 Rev. A07 069001184 Rev. A11 300-001-335 Rev. A11 300-004-210 Rev. A02 069001181 Rev. A14 FC series; C series 069001038 Rev. A14 300-001-335 Rev. A11 EMC® VNX® Series Command Line Interface Reference for Block 15