Dell Vostro 1400 Service Manual - Page 37

Replacing the Palm Rest

Get Dell Vostro 1400 PDF manuals and user guides View all Dell Vostro 1400 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 37 highlights

1 palm rest 2 M2.5 x 5mm screws (3) 3 Bottom of the system 8. Disconnect the touch pad cable. Use a plastic scribe to release the locking clips on both sides of the system board connector, and then gently pull to disconnect the touch pad connector from the system board connector. 9. Disconnect the LED board cable. 1 touch pad cable 2 palm rest 3 LED board cable 10. Moving from left to right, carefully lift the palm rest along the rear edge, near the hinge brackets, then rotate the palm rest forward to remove it from the computer. Replacing the Palm Rest CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as the back panel on the computer. 1. Follow the instructions in Before You Begin 2. Follow the instructions in Removing the Palm Rest.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
8.
Disconnect the touch pad cable.
Use a plastic scribe to release the locking clips on both sides of the system board connector, and then gently pull to disconnect the touch pad connector
from the system board connector.
9.
Disconnect the LED board cable.
10.
Moving from left to right, carefully lift the palm rest along the rear edge, near the hinge brackets, then rotate the palm rest forward to remove it from the
computer.
Replacing the Palm Rest
1.
Follow the instructions in
Before You Begin
2.
Follow the instructions in
Removing the Palm Rest
.
1
palm rest
2
M2.5 x 5mm screws (3)
3
Bottom of the system
1
touch pad cable
2
palm rest
3
LED board cable
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the
Product Information Guide
.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as the back panel on the computer.