Dell Vostro 3030 Small Desktop Owners Manual - Page 68
Processor, Removing the processor
![]() |
View all Dell Vostro 3030 Small manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Figure 49. Installing the processor fan and heat-sink assembly Steps 1. Gently align and place the processor fan and heat-sink assembly on the processor. NOTE: The side of the fan with the word 'REAR' written must face the rear of the chassis. NOTE: The stubs on the fan shroud must align to the corresponding stub holes on the processor fan. 2. Align the screw holes on the processor fan and heat-sink assembly with the screw holes on the system board. 3. In a sequential order (1>2>3>4), tighten the four captive screws to secure the processor fan and heat-sink assembly on the system board. 4. Connect the fan and heat-sink assembly cable to the connector on the system board. Next steps 1. Install the hard-drive and optical-drive cage. 2. Install the fan shroud. 3. Install the left-side cover. 4. Follow the procedure in After working inside your computer. Processor Removing the processor CAUTION: The information in this section is intended for authorized service technicians only. Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the left-side cover. 68 Removing and installing Field Replaceable Units (FRUs)
![](/manual_guide/products/dell-vostro-3030-small-desktop-owners-manual-ce98706/68.png)