Dell W-7005 MNT-19 Mounting Kit Installation Guide - Page 1

Dell Networking W-7005-MNT-19 Mounting Kit Installation Guide This document provides installation instructions for mounting the W-7005 controller in a two-post 19-inch Telco rack. Package Contents  Rack mount tray  Four M3 x 5 mm flat head screws  Four M6 x 15 mm Phillips pan head screws  Four M6 Cage Nut  Four M6 Clip Nut  Installation Guide (this document, printed) Rack Mount Installation This mounting option allows mounting the W-7005 controller in a two-post 19-inch Telco rack. Required Tools and Equipment The following tools and equipment are required for installing a W-7005 controller:  Rack mount tray (x1) for rack mount installation  M3 x 5 mm flat head screws (x4) for securing the controller on the rack mount tray  M6 x 15 mm Phillips pan head screws (x4) for rack mount  M6 cage nut (x4): Optional  M6 clip nut (x4): Optional  Suitable screwdrivers for all screw types provided in the box (not included in the kit) NOTE: Some racks require screws that differ from those included with the W-7005 controller accessory kit. Ensure that you have the correct screws before installing the W-7005 controller. Installation Steps To install a W-7005 controller into a two post 19-inch rack: 1. Route and secure the DC power cable correctly into the slot provided at the bottom of the controller. See Figure 1. 2. Place the controller on the rack mount tray such that the DC cable is not obstructed. See Figure 2. 0511738-03 | March 2015 1