Dell W-Series 205H Instant 6.5.1.0-4.3.1.0 CLI Reference Guide - Page 2048

The output of this command includes the following information: Parameter Description Active Shows if the controller is active on the network. l 1: Active l 0: Inactive MAC-Address MAC address of the local controller. IP-Address IP address of the local controller. Sequence Number The number of times the local controller in the whitelist received and acknowledged a remote AP whitelist change from the master controller. In the example above, both local controllers received and acknowledged three remote AP whitelist changes sent from the master controller. Remote Sequence Number The number of times that the master controller has received and acknowledged a remote AP whitelist change from the local controller in the whitelist. In the example above, the master controller received and acknowledged a single remote AP whitelist change from the local controller with the MAC address 00:0b:86:51:a5:4c. Null Update Count The number of times the controller has checked its remote AP whitelist and found nothing to synchronize with the remote controller. By default, the controller compares its remote AP whitelist against whitelists on other controllers every minute. If the null update count reaches 5, the controller will send an "empty sync" heartbeat to the remote controller to ensure the sequence numbers on both controllers are the same, then reset the null update count to zero. Related Commands Command show whitelist-db rap-masterswitch-list whitelist-db rap del Description Delete a master controller from the master switch table used by the remote AP whitelist Remove an AP entry from the remote AP whitelist. Mode Config mode Config mode Command History Version ArubaOS 6.3 Modification Command introduced 2048| show whitelist-db rap-local-switch-list Dell Networking W-Series ArubaOS 6.5.x | Reference Guide