Dell Wyse R Class Implementing FCoE in the Linux Operating System - Page 12
Setting up FCoE for SLES 11 SP 2
View all Dell Wyse R Class manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Implementing FCoE in the Linux Operating System Setting up FCoE for SLES 11 SP 2 Installing / verifying FCoE support If FCoE support has not been installed in SLES 11 SP2, it must be installed. To verify if FCoE support was installed in SLES 11 SP2, perform the following steps: 1. Log-in as root, then the start YaST2 Control Center by running the yast command. From YaST2, select Network Services in the left-side menu, then use the Tab key switch to the right-side menu. Use the arrow keys to scroll up and down the list of Network Services and look for FCoE Client Configuration; if FCoE Client Configuration is not listed, as in Figure 5, then FCoE support is not installed in SLES 11 SP2, and must be installed at this time. Figure 5. FCoE support not installed. 12