Dell Wyse R Class Implementing FCoE in the Linux Operating System - Page 14

Con the FCoE client VLAN

Get Dell Wyse R Class PDF manuals and user guides View all Dell Wyse R Class manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Implementing FCoE in the Linux Operating System Figure 7. Selecting FCoE packages for installation. You may be prompted to accept any Automatic Changes to resolve dependency issues; if this happens, select OK to allow the installation to proceed. After the packages install, you are returned to the YaST2 Control Center. When finished, quit the YaST2 Control Center. Configure the FCoE client VLAN Next, configure the FCoE client VLAN by performing the following steps: 1. Start the YaST2 Control Center using the yast command, then select Network Services, and then FCoE Client Configuration, as in Figure 8. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Implementing FCoE in the Linux Operating System
14
Selecting FCoE packages for installation.
Figure 7.
You may be prompted to accept any
Automatic Changes
to resolve dependency issues; if this
happens, select
OK
to allow the installation to proceed.
After the packages install, you are
returned to the YaST2 Control Center. When finished, quit the YaST2 Control Center.
Configure the FCoE client VLAN
Next, configure the FCoE client VLAN by performing the following steps:
1.
Start the YaST2 Control Center using the
yast
command, then select
Network Services
,
and then
FCoE Client Configuration
, as in Figure 8.