Dell X1000 Series Switches Getting Started Guide - Page 7
Flat Surface Installation
View all Dell X1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Figure 1-1. Bracket Installation for Rack Mounting 2 Insert the supplied screws into the rack mounting holes and tighten with a screwdriver. 3 Repeat the process for the rack-mounting bracket on the other side of the switch. 4 Insert the switch into the rack, making sure the rack-mounting holes on the switch line up to the mounting holes on the rack. 5 Secure the switch to the rack with the rack screws (not provided). Fasten the lower pair of screws before the upper pair of screws. Make sure that the ventilation holes are not obstructed. Flat Surface Installation The switch can be installed on a flat surface if it is not installed on a rack. The surface must be able to support the weight of the switch and the switch cables. 1 Attach the self-adhesive rubber pads (provided with the switch) on each marked location on the bottom of the chassis. 2 Set the switch on a flat surface, while leaving two inches (5.08 cm) on each side and five inches (12.7 cm) at the back. Getting Started Guide 5