Denon 488BA Owners Manual - English - Page 6
About the Remote Control Unit - avr
UPC - 883795000086
View all Denon 488BA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Getting Started Connections Setup Playback Remote Control Information Troubleshooting ENGLISH About the Remote Control Unit In addition to the AVR-488, the included remote control unit (RC-1079) can also be used to operate the equipment listed below. q DENON system components w Non-DENON system components • By setting the preset memory (vpage 37 ~ 39) Operating Range of the Remote Control Unit Point the remote control unit at the remote sensor when operating it. Inserting the Batteries q Lift the clasp and remove the rear lid. w Load the two batteries properly as indicated by the marks in the battery compartment. R6P/AA Approx. 23 feet / 7 m 30° 30° e Put the rear cover back on. NOTE • Replace the batteries with new ones if the set does not operate even when the remote control unit is operated close to the unit. • The supplied batteries are only for verifying operation. • When inserting the batteries, be sure to do so in the proper direction, following the "q" and "w" marks in the battery compartment. • To prevent damage or leakage of battery fluid: • Do not use a new battery together with an old one. • Do not use two different types of batteries. • Do not attempt to charge dry batteries. • Do not short-circuit, disassemble, heat or dispose of batteries in flames. • If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries. • Remove the batteries from the remote control unit if it will not be in use for long periods. • When replacing the batteries, have the new batteries ready and insert them as quickly as possible. NOTE The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.