Denon AVR 1609 Owners Manual - English - Page 40

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications ENGLISH Playback Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit BUTTON Button only on the main unit Button only on the remote control unit [BUTTON] SOURCE SELECT ack Preparations Turning the Power On 1 Press . The power indicator lights red and the power is set to the standby mode. 2 Press or [ON/SOURCE]. The power indicator flashes green and the power turns on. b Also press [SOURCE SELECT] when in standby mode, the power turns on. In this case the input source is selected by remote control unit. b Also press [QUICK SELECT] when in standby mode, the power turns on. In this case Quick Select is selected by remote control unit (vpage 44). BAND TUNING [Front] [Rear] [ON/SOURCE] [OFF] [QUICK SELECT] SOURCE SELECT [TUNER] [MASTER VOLUME] TUNING [MUTING] [TUNER] SOURCE SELECT [V.SEL] TUNING [MODE] BAND [INPUT] [SOURCE CONTROL 1] [SOURCE CONTROL 2] Turning the Power Off qPress or [OFF]. The power is set to the standby mode. wPress . The power indicator turns off, and so does the power. NOTE Power continues to be supplied to some of the circuitry even when the power is in the standby mode. When leaving home for long periods of time or when traveling, either press to turn off the power, or unplug the power cord from the power outlet. Selecting the Input Source Select the source using SOURCE SELECT. Turn or press [SOURCE SELECT] to switch between input sources. If "Rec Select" is selected for the input source, press before turning . Setting the Input Mode Set the input mode for this source. Press or [INPUT]. Each time you press the button, the input mode display will change. Auto PCM DTS EXT. IN Analog [Selectable items] Auto : Detect type of digital input signal and decode and play automatically. PCM : Decode and play only PCM input signals. DTS : Decode and play only DTS input signals. Analog : Play only signals from analog input. EXT. IN : Play only signals from EXT. IN input. • When a digital signal is properly input, the " " indicator lights on the display. If the " " indicator does not light, check the digital input connector assignment and the connections. • The surround mode cannot be set if the input mode is set to "EXT. IN". • Only set "PCM" and "DTS" when playing the respective signals.