Denon AVR-1912 Owners Manual - Page 59
Set up speakers, Set up the, remote control unit, Press ZONE SELECT, Press AMP, Set up Amp Assign - zones
UPC - 883795001984
View all Denon AVR-1912 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Basic version Advanced version Set up speakers around items indicate the settings. Here we describe how to set up speakers other than 5.1-channel speakers. For the method of setting up 5.1-channel speakers, see C page 4 "Setup wizard". First install and connect the speakers to this unit. Before Auto Setup measurement, the settings shown below can be made. • Changing the amplifier assignment (Amp Assign) The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment (vpage 56 "Set up "Amp Assign""). • Setting the channels to be used (Channel Select) If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage 57 "Set up "Channel Select""). 1 Set up the remote control unit nn Set up the zone mode Press ZONE SELECT to switch the zone mode to J (MAIN ZONE). The J indicator lights. 2 Connect the setup microphone. When the setup microphone is connected, the following screen is displayed. Press ZONE SELECT nn Set up the operation mode Press AMP to set the remote control unit to AMPoperation mode. Audyssey Auto Setup MultEQ Preparation Connect the speakers and place then according to the recommendations in the manual. Next [ENTER] Enter [RETURN] Cancel 4 Set up "Amp Assign" Use ui to select "Amp Assign", and then press ENTER. Audyssey Auto Setup Preparation Set the following items if necessary. MultEQ Amp Assign Channel Select Auto Setup Start [ENTER] Enter [RETURN] Cancel Amp Assign Amp Assign ZONE2 MultEQ Press AMP 3 Select "Next", and then press ENTER. [ENTER] Enter ZONE2 [RETURN] Cancel vSee overleaf Information 56