Denon AVR 4308CI Owners Manual - English - Page 35

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications g Manual EQ Adjust tonal quality for each speaker using graphic equalizer. Adjust CH Select speaker adjustment method. [Selectable items] Each L/R All Manual EQ Select the speaker and frequency band and adjust the level. [Selectable items] 63 125 250 500 1k 2k 4k 8k 16k [Variable range] -20dB ~ 0dB ~ +6dB Curve Copy Copy "Audyssey Flat" curve from Room EQ. [Selectable items] Yes No "Curve Copy" is displayed after the auto setup procedure has been performed. Default Resets the settings to the default values. Network Setup Make network settings. F Menu tree F Manual Setup Network Setup a Network Setup s Other d Network Information • If you are using a broadband router (DHCP function), there is no need to make the settings at "Setting the IP Address" and "Setting the Proxy", since the DHCP function is set to "ON" in the AVR-4308CI's default settings. • If the AVR-4308CI is being used connected to a network without the DHCP function, the network settings must be made. In this case, some knowledge of networks is required. For details, consult a network administrator. • If you cannot connect to the Internet, recheck the connections and settings (vpage 20). • If you do not understand about Internet connection, contact your ISP (Internet Service Provider) or the store from which you purchased your computer. • DHCP (Dynamic Host Configuration Protocol) : These are systems by which the IP address and other network settings are automatically set for the AVR-4308CI, computer, broadband router and network devices. • DNS (Domain Name System) : This is a system for converting the domain names used when browsing Internet sites (for example, "www.denon.jp") into the IP addresses actually used for communications (for example, "202.221.192.106"). a Network Setup Make settings for wired or wireless LAN. Wired LAN settings Use this procedure to configure the Wired LAN settings. 1 Connect the LAN cable (vpage 20). 2 Turn on the AVR-4308CI (vpage 49). AVR-4308CI performs automatic network setup due to the DHCP function. When connecting to a network that has no DHCP function, perform the setting in step 3. 3 Set the IP address at the GUI menu "Manual Setup" "Network Setup" - "Network Setup". q Select "Detail". e Input the address. w Set "OFF". r Select "Exit". q Select "Detail" and press the ENTER button. w U se the o p button to set "DHCP" to "OFF", then press the i button. The DHCP function is disabled. 32