Denon AVR 4308CI Owners Manual - English - Page 75

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications Switching Zones Use this procedure to select the zone to be operated by the sub remote control unit. 1 Press [ZONE SELECT]. The currently selected multi-zone indicator lights. 2 While the multi-zone indicator is light, press [ZONE SELECT] to select the zone to be operated. The currently selected multi-zone indicator lights. Setting the Zone for Which the Sub Remote Control Unit is Used (ZONE SELECT LOCK Mode) We recommend always using the sub remote control unit for the same room. When this is done, the unit can be set so that the zone does not switch when buttons are operated. 1 Use the tip of a pen to press [ADVANCED SETUP]. All the multi-zone indicators light. 2 Select the multi-zone to be set. The selected multi-zone indicator lights. qTo set to "MAIN ZONE" : Press [REPEAT]. wTo set to "ZONE2" : Press [RANDOM]. eTo set to "ZONE3" : Press [USB]. rTo set to "ZONE4" : Press [ALL MUSIC/FAVORITES]. 3 Use the tip of a pen to press [ADVANCED SETUP]. The multi-zone indicator turns off. To Cancel 1 Use the tip of a pen to press [ADVANCED SETUP]. The currently selected multi-zone indicator lights. 2 Press [ZONE SELECT]. All the multi-zone indicators light. 3 Use the tip of a pen to press [ADVANCED SETUP]. The multi-zone indicator turns off. Setting the Remote ID When using multiple DENON AV receivers in the same room, make this setting so that no AV receiver other than the desired one operates. 1 While pressing [MENU], press [ADVANCED SETUP] with the tip of a pen. The multi-zone indicator corresponding to the currently selected remote ID flashes. 2 Select the remote ID to be set. qTo set to 1 : Press [REPEAT]. The "M" indicator flashes. wTo set to 2 : Press [RANDOM]. The "Z2" indicator flashes. eTo set to 3 : Press [USB]. The "Z3" indicator flashes. rTo set to 4 : Press [ALL MUSIC/FAVORITES]. The "Z4" indicator flashes. 3 While pressing [MENU], press [ADVANCED SETUP] with the tip of a pen. The multi-zone indicator turns off. NOTE When changing a setting, be sure to set the same remote ID as the AVR-4308CI's (vpage 38). Resetting the Settings While pressing [ZONE OFF], press [ADVANCED SETUP] with the tip of a pen. All the multi-zone indicators flash 4 times, then all the settings are restored to their defaults. Amp Assign / Multi Zone Connections and Operations The AVR-4308CI is compatible with the following types of playback: • Multi-zone playback (ZONE2 & ZONE3) • Bi-amp playback (front speaker) • Bi-wiring playback (front speaker) NOTE • For bi-amp and bi-wiring playback, use speakers compatible with that type of connection. • When conducting bi-amp or bi-wiring playback, remove the short- circuiting boards (or wires) from the speaker terminals. Multi-Zone Settings with the Amp Assign Function The amp assign function lets you assign the amplifiers for the different channels built into the AVR-4308CI to the speaker outputs for the different zones. Select the desired playback environment from among "Setting 1" to "Setting 6", then set the corresponding "Amp Assign" mode at GUI menu "Manual Setup" - "Option Setup" - "Amp Assign" (vpage 37). Connect the speakers as described at "Speaker connections". With "Setting 4" to "Setting 6", it is possible to switch the Amp Assign mode between the 7.1-channel mode and the multizone mode without changing the speaker connections. 72