Denon AVR-790 Owners Manual - English - Page 24

Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications ENGLISH Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup) Step 1 : Connect the included Setup Microphone NOTE • Do not disconnect the setup microphone until the Audyssey Auto Setup procedure is completed. • When using headphones, unplug the headphones before starting the Audyssey Auto Setup procedure. 1 Check the speaker connections. (vpage 11 "Connecting the Speakers") 2 Turn on the power of the TV and subwoofer. Set the TV's input to the AVR-790. 3 Turn on the AVR-790's power. (vpage 17 "Turning the Power On") 4 Connect the included calibrated setup microphone to the SETUP MIC jack on the main unit. The Audyssey Auto Setup screen appears automatically. NOTE • Do not hold the microphone in your hand during measurements. • Avoid placing the microphone close to a seat back or wall as sound reflections may give inaccurate results. When using a subwoofer on which the volume can be adjusted and the crossover frequency can be set When using a subwoofer, make the following settings before starting the Audyssey Auto Setup procedure: n When using a subwoofer with a direct mode Set the direct mode to "On" and disable the volume adjustment and crossover frequency setting. n When using a subwoofer without a direct mode Make the following settings: • Volume :"12 o'clock position" • Crossover frequency :"Maximum/Highest Frequency" • Low pass filter :"Off" • Standby mode :"Off" Sound receptor 5 Mount the setup microphone on a tripod or stand and install it at the main listening position. When installing the setup microphone, adjust its height so that the section where the sound is received is at the height of the ears during listening. Setup microphone Step 2 : Audyssey Auto Setup Preparations around items indicate the settings made upon purchase. If adjustment to the environment is necessary, set the following items before proceeding. Changing the amplifier assignment (Amp Assign) The signals output from the AVR-790's SURR. BACK/AMP ASSIGN speaker terminals can be switched to signals of the surround mode being used. 1 Press ui to select "Amp Assign". Front 2 Press o p to select Amp Assign Mode. 3-1.Audyssey Auto Setup MultEQ Please place microphone at ear height at main listening position. Amp Assign: Normal Start Cancel [ENT]:Select [RTN]:Back Normal : The sound of the surround back channel is output from the speakers connected to the SURR. BACK/AMP ASSIGN terminals. ZONE2 : If the ZONE2 power is on, the sound of the ZONE2 channel is output from the speakers connected to the SURR. BACK/AMP ASSIGN terminals. Front Bi-Amp : The sound of the front bi-amp channel is output from the speakers connected to the SURR. BACK/AMP ASSIGN terminals. Front Height : The sound of the front height channel is output from the speakers connected to the SURR. BACK/AMP ASSIGN terminals. n To cancel Audyssey Auto Setup Use ui to select "Cancel", then use o p to select "Yes". 21