Denon AVR-790 Owners Manual - English - Page 26

Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications ENGLISH NOTE Do not change the speaker connections or subwoofer volume, or speaker locations after making measurements. If changes are necessary, make the changes and use the Audyssey Auto Setup once again for an updated EQ solution. Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup) Error Messages If the Audyssey Auto Setup procedure could not be completed due to speaker installation, the measuring environment, etc., an error message is displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform the Audyssey Auto Setup procedure over again. NOTE Be sure to turn the power off before checking the speaker connections. • If the result differs from the actual connection status or an error message appears, use ui to on-screen display "Retry" and then press to repeat the measurement. • If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn the AVR-790 off, check the speaker connections and repeat the measurement process from the beginning. • For instance, If the location or direction of a speaker is altered, the Audyssey Auto Setup should be performed again to ensure the correct EQ solution for the new room configuration. Error messages (examples) Caution MultEQ FMicrophone:None or Speaker :None Cause • Included setup microphone is not connected. • Not all speakers could be detected. • The front L speaker was not properly detected. Measures • Connect the included setup microphone to the SETUP MIC jack on the main unit. • Check the speaker connections. Retry Cancel [ENT]:Retry Caution MultEQ FAmbient noise is too high or Level is too low. Retry Cancel [ENT]:Retry • Too much noise in the room for accurate measurements to be made. • Speaker or subwoofer sound is too low for accurate measurements to be made. • Either turn off any device generating noise or move it away. • Try again when the surroundings are quieter. • Check the speaker installation and the direction in which the speakers are facing. • Adjust the subwoofer's volume. Caution MultEQ Front R :None Retry Cancel Skip [ ]:Up/Down [ ]:CH Caution MultEQ Front L :Phase Retry Cancel Skip [ ]:Up/Down [ ]:CH • Displayed speaker could not be detected. · The front R speaker were not properly detected. · Only one channel of the surround speakers was detected. · Sound was output from the R channel when only one surround back speaker was connected. · The surround back, but the surround speaker was not detected. • Displayed speaker connected with the polarities reversed. • Check the connections of the displayed speaker. • Check the polarities of the displayed speaker. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure that the wiring is correct, press ui to select "Skip", then press . n To perform the Audyssey Auto Setup procedure again Press ui to select "Retry", then press . n To cancel Audyssey Auto Setup Use ui to select "Cancel", then select "Yes" using o p. 23