Denon AVR-791 Owners Manual - English - Page 7
Install, Connect - with speakers
UPC - 883795001359
View all Denon AVR-791 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ENGLISH 1 Install 2 1 2 3 4 5 Connect 1 2345 This unit can perform 2.0/2.1 to 7.1-channel surround playback. Here, we explain setup using the example of 5.1-channel speaker playback. FL SW 120˚ FR C 22 - 30˚ Speakers Carefully check the left (L) and right (R) channels and + (red) and - (black) polarities on the speakers being connected to the this unit, and be sure to interconnect the channels and polarities correctly. Connecting the speaker cables Peel off about 0.03 ft/10 mm of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it. NOTE • Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and - sides touch each other (vpage 75 "Protection Circuit"). • Never touch the speaker terminals while the power supply is connected. Doing so could result in electric shock. • Use speakers with the speaker impedances shown below. Speaker terminals FRONT CENTER SURROUND SURR. BACK / AMP ASSIGN Speaker impedance 6 - 16 Ω SL SR Listening position FL Front speaker (L) FR Front speaker (R) C Center speaker SW Subwoofer SL Surround speaker (L) SR Surround speaker (R) • Install the surround speakers in a position 2 to 3 ft (60 to 90 cm) higher than ear level. Surround Front speaker speaker 2 - 3 ft / 60 - 90 cm GViewed from the sideH When using a banana plug Tighten the speaker terminal firmly before inserting the banana plug. 4 The "Simple version" describes the installation, connection and setup methods for 5.1-channel speakers. See page 30 for the installation, connection and setup methods for speakers other than 5.1-channel speakers.