Denon DRA-697CIHD Owners Manual - English - Page 25

ENGLISH Operating the remote control unit Operating DENON audio components 1 Set [MODE SELECTOR 1] to "A" or "B". 2 Set [MODE SELECTOR 2] to the position for the component to be operated. 3 Operate the audio component. For details, refer to the component's operating instructions. While this remote control is compatible with a wide range of infrared controlled components, it may be the case that some component models cannot be operated with this remote control. Setting the preset memory function • DENON and other makes of components can be operated by setting the preset memory. • This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the manufacturer of the component as shown in the list of preset codes ( End of this manual). • Operation is not possible for some models. 4 Referring to the included list of preset codes, press [NUMBER] to input the preset code (a 3-digit number) for the manufacturer of the component whose signals you want to store in the memory. 5 To store the codes of another component in the memory, repeat steps 1 to 4. • The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control unit's transmitting window while setting the preset memory. • Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed in the list of preset codes. • Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and verify correct operation. • The preset memory can be set for one component only among the following: CD/iPod, DBS/CABLE and CD-R/TAPE. Setting the punch through function "Punch Through" is a function allowing you to operate 1, 2, 0, 3, 6, 7, 8 and 9 on CD, DVD/VDP, TAPE/CD-R/MD or VCR components when in the TV or DBS/CABLE mode. By default, nothing is set. 1 Set [MODE SELECTOR 1] to "A". 2 Set [MODE SELECTOR 2] to the component to be registered (TV or DBS/CABLE). 3 Press [A] and [D] at the same time. • The indicator starts flashing. 4 Input the number of the component you want to set. No. CD 1 DVD/VDP 2 TAPE/CD-R/MD 3 VCR 4 No setting 0 1 Set [MODE SELECTOR 1] to "A" or "B". Set to the A side for the CD/iPod, TV, DBS/CABLE or DVD position, and to the B side for the CD-R/TAPE or VCR position. Operating a component stored in the preset memory 2 Set [MODE SELECTOR 2] to the component to be registered. 3 Press [ZONE2 OFF] and [ZONE3 ON] at the same time. • The indicator starts flashing. 1 Set [MODE SELECTOR 1] to "A" or "B". Set to the A side for the CD/iPod, TV, DBS/CABLE or DVD position, and to the B side for the CD-R/TAPE or VCR position. 2 Set [MODE SELECTOR 2] to the component you want to operate. 3 Operate the component. For details, refer to the component's operating instructions. Some models cannot be operated with this remote control unit. 22 ENGLISH