Denon S-101 Owners Manual - Eng/Span - Page 27

ENGLISH Basic Operation Listening to the radio Manual tuning 1 Set the input source to "TUNER". (Main unit) (Remote control unit) 2 Press the BAND button on the main unit to select "FM AUTO", "FM MONO" or "AM". When using the remote control, the BAND button is pressed to select "FM" or "AM", then the MODE button is pressed to select "FM AUTO" and "FM MONO". 3 Adjust the receiving frequency. • When a station is received, the "TUNED" indication will light. (Main unit) (Remote control unit) • A humming sound may be heard when using a TV nearby while receiving AM programs. If this happens, move the system as far from the TV as possible. 2 FM stereo perception • When a program being broadcast in "FM AUTO" is received, the "ST" indicator lights and the program is received in stereo. • If reception is poor and there is much noise in the stereo signals, set the "FM AUTO" mode. 2 About the tuning mode and the preset mode • The function of the + and - buttons on the main unit can be switched so that they can be used for either tuning (selecting the reception frequency) or for selecting preset stations. • The buttons are set to the tuning mode upon shipment. The mode can be switched to the preset mode by pressing the + button while pressing in the BAND button. (When this is done, "PRESET" is flashes for approximately 5 seconds.) • Press the - button while pressing in the BAND button to switch to the tuning mode. (When this is done, "TUNING" is flashes for approximately 5 seconds.) 2 Auto tuning • When one of the + or - button on the main unit (or the SLOW/SEARCH button on the remote control unit) is pressed, the frequency changes in steps of 0.2 MHz in the FM band, 10 kHz in the AM band. • If one of the + or - button on the main unit (or the SLOW/SEARCH button on the remote control unit) is held for over 1 second, the frequency continues to change when the button is released (Auto tuning) and stops when a station is tuned in. Tuning will not stop at stations whose reception is poor. • To stop the auto tuning function, press the + or - button on the main unit (or the SLOW/SEARCH button on the remote control unit) once. • The CURSOR 0 and 1 buttons function in the same way as the + and - buttons on the main unit and remote control unit. Basic Operation Auto tuner presets (for main unit only) Use this to automatically search for FM broadcasts and store up to 60 stations at preset channels 1 to 60. 1 Set the input source to "TUNER", then press and hold the 1 button for 2 seconds or longer. • "AUTO PRESET?" and "-:NO/+: START" will alternately appear on the display of the main unit. Press the - button to cancel. 2 Press the + button to select "START". • "SEARCH" flashes on the display and searching begins. "COMPLETED" appears once searching is completed. • If an FM station cannot be preset automatically due to poor reception, use the "Manual tuning" ( page 24) operation to tune in the station, then preset it using the manual "Preset memory" ( page 25) operation. • When the auto preset function is performed, the previously presettings are cleared and replaced with the new presettings. Listening to preset stations The buttons are set to the tuning mode upon shipment. The mode can be switched to the preset mode by pressing the + button while pressing in the BAND button. (When this is done, "PRESET" is flashes for approximately 5 seconds.) Press the + or - button on the main unit, or TUNING + or - button on the remote control unit to select the preset number. 24 ENGLISH (Main unit) (Remote control unit) The preset number can also be input directly pressing the NUMBER buttons on the remote control unit. The + and - buttons on the main unit can be selected when the preset mode has been set.