Denon S81 Owners Manual - English - Page 32

Others

Page 32 highlights

ENGLISH Others Troubleshooting If a problem should arise, first check the following. 1. Are all connections proper? 2. Is the set being operated as described in the operating instructions? 3. Are the speakers and other components operating properly? If this unit is not operating properly, check the items listed in the table below. Should the problem persist, there may be a malfunction. Disconnect the power immediately and contact your store of purchase. ¢ Common section Symptom Cause Measures Page Display does not light and • The power supply cord is not plugged • Plug the power supply cord into a 12 no sound is produced into a power outlet. power outlet. when power is turned on. Remote control unit does • The batteries are flat. • Replace with new batteries. 4 not operate. • The remote control unit is too far • Operate from closer to the main unit. 4 away. • There is an obstacle between the • Remove the obstacle. 4 main unit and the remote control unit. • The remote control unit is being • Operate the remote control unit from 4 operated at an angle of over 30° with directly in front of the main unit. respect to the front panel. • The batteries are inserted in the • Insert the batteries in the proper 4 wrong direction. direction. ¢ Receiver section Others Symptom Cause Measures Page Display lights but no • The speaker cables are not properly • Connect securely. sound is produced. connected. • The input is not properly selected. • Connect in the proper position. • The volume is set too low. • Adjust the volume to an appropriate level. 8 10, 11, 12 13 No sound is produced from once side. • The speaker cables are not properly connected. • The input cables are not properly connected. • The left/right balance is off. • Connect securely. • Connect securely. • Adjust the left/right balance. 8 10, 11 12 13 For stereo sources, the • The connections of the speaker • Check the connections. positions of the cables or input cables are inverted. instruments are inverted. 8, 10, 11, 12 Buzzing noise in FM • The antenna cable is not properly • Connect the antenna properly. 9 broadcasts. connected. • Noise is entering from an electronic • Change the layout of the equipment 9 device equipped with a microprocessor, or the positions or directions of the or the signal from the broadcast connection cables, antenna, etc. system is weak. • Connect an outdoor antenna. 9 Hissing or buzzing noise • Noise is entering from a monitor, etc., • Turn off the monitor. - is heard in AM broadcasts. or there is interference. • Change the position or direction of 9 the AM loop antenna. • Connect an outdoor antenna. 9 Humming noise is heard • There is interference from signals • Connect an outdoor antenna. 9 in AM broadcasts. conveyed through the power supply cord. "CHECK ANTENNA" is • S-81's XM terminal and the XM • Check that the connection are 10 displayed in the XM Connect-and-Play antenna is not correct. mode. properly connected. "NO SIGNAL" is • The signal cannot be received. displayed in the XM mode. • Reposition your XM Connect-and- 17 Play antenna. "OFF AIR" is displayed • The selected channel is not currently • Select the another channel. 17 in the XM mode. broadcasting. Receiving only XM • The XM Tuner is not activated. • Contact XM Radio. 16 channels 0 and 1. No sound is produced • Connections are wrong. • Connect properly. when an iPod is • The "iPod CONTROL" switch on the • Set the "iPod CONTROL" switch on connected and played. rear panel is not set to the right the rear panel to the proper position. position. 10, 11 10, 11 28 ENGLISH

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

ENGLISH
Others
28
Symptom
Cause
Measures
Page
Others
If a problem should arise, first check the following.
1.
Are all connections proper?
2.
Is the set being operated as described in the operating instructions?
3.
Are the speakers and other components operating properly?
If this unit is not operating properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction. Disconnect the power immediately and contact your store of purchase.
Display does not light and
no sound is produced
when power is turned on.
• The power supply cord is not plugged
into a power outlet.
• Plug the power supply cord into a
power outlet.
12
Troubleshooting
¢
Common section
Remote control unit does
not operate.
• The batteries are flat.
• The remote control unit is too far
away.
• There is an obstacle between the
main unit and the remote control unit.
• The remote control unit is being
operated at an angle of over 30° with
respect to the front panel.
• The batteries are inserted in the
wrong direction.
• Replace with new batteries.
• Operate from closer to the main unit.
• Remove the obstacle.
• Operate the remote control unit from
directly in front of the main unit.
• Insert the batteries in the proper
direction.
4
4
4
4
4
Symptom
Cause
Measures
Page
Display lights but no
sound is produced.
• The speaker cables are not properly
connected.
• The input is not properly selected.
• The volume is set too low.
• Connect securely.
• Connect in the proper position.
• Adjust the volume to an appropriate
level.
8
10, 11,
12
13
No sound is produced
from once side.
• The speaker cables are not properly
connected.
• The input cables are not properly
connected.
• The left/right balance is off.
• Connect securely.
• Connect securely.
• Adjust the left/right balance.
8
10, 11
12
13
For stereo sources, the
positions
of
the
instruments are inverted.
• The connections of the speaker
cables or input cables are inverted.
• Check the connections.
8, 10,
11, 12
Buzzing noise in FM
broadcasts.
• The antenna cable is not properly
connected.
• Noise is entering from an electronic
device equipped with a microprocessor,
or the signal from the broadcast
system is weak.
• Connect the antenna properly.
• Change the layout of the equipment
or the positions or directions of the
connection cables, antenna, etc.
• Connect an outdoor antenna.
9
9
9
Hissing or buzzing noise
is heard in AM broadcasts.
• Noise is entering from a monitor, etc.,
or there is interference.
• Turn off the monitor.
• Change the position or direction of
the AM loop antenna.
• Connect an outdoor antenna.
9
9
Humming noise is heard
in AM broadcasts.
• There is interference from signals
conveyed through the power supply
cord.
• Connect an outdoor antenna.
9
¢
Receiver section
10, 11
10, 11
No sound is produced
when
an
iPod
is
connected and played.
• Connections are wrong.
• The “iPod CONTROL” switch on the
rear panel is not set to the right
position.
• Connect properly.
• Set the “iPod CONTROL” switch on
the rear panel to the proper position.
ENGLISH
“CHECK ANTENNA” is
displayed in the XM
mode.
S-81’s XM terminal and the XM
Connect-and-Play antenna is not
properly connected.
Check that the connection are
correct.
10
“NO
SIGNAL”
is
displayed
in
the
XM
mode.
The signal cannot be received.
Reposition your XM Connect-and-
Play antenna.
17
“OFF AIR” is displayed
in the XM mode.
The selected channel is not currently
broadcasting.
Select the another channel.
17
Receiving
only
XM
channels 0 and 1.
The XM Tuner is not activated.
Contact XM Radio.
16