Dewalt D28494N Instruction Manual - Page 12
Rotating the Rear Handle, Rotating the Gear Case, ASSEMBLY AND ADJUSTMENTS, Attaching the Side
View all Dewalt D28494N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
399080-02 rev 11/15/02 10:13 AM Page 8 English CAUTION: Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other accessories running over rated speed can fly apart and cause injury. • Two rear positions: Rear handle positions are designed for optimized balance in edge grinding applications. ATTACHMENTS Attachments designed specifically for this grinder can be purchased through DEWALT dealers and DEWALT Factory Service centers. • One top position: Top handle position is designed for edge grinding applications. NOTE: D28497 includes only three handle positions. D284939 9" Type 27 guard Rotating the Rear Handle D284948 D284937 D284936 D284934 D284933 D284932 9" Type 28 guard 7" Type 27 guard 6" Type 11 Flaring cup guard with flange 4" Type 11 Flaring cup guard with flange Type 11 flaring cup wheel backing flange Type 1 Flange set Turn off and unplug tool before making any adjustments or removing or installing accessories. Before reconnecting the tool, depress and release the trigger switch to ensure that the tool is off. 1. Unlock the rear handle by pulling out the Handle Release Lever (G) as shown. D284931 7" Type 1 Guard 2. Rotate handle into available 054339-00 Grinding backing flange 22191-00 Clamp nut 61820-01 Wheel Wrench 445928-01 Soft mount spindle protector 397711-00 Rubber gear case bumper ASSEMBLY AND ADJUSTMENTS 0°, 30°, 60°, or 90° position left OR right of center. 3. Push in the handle release G lever. 4. Before turning the tool on, ensure that the handle is locked into a position and the handle release lever has returned to the original position flush with the tool housing. Attaching the Side Handle Rotating the Gear Case To install the side handle, thread the handle into one of the five positions listed below and tighten securely by turning clockwise. Turn off and unplug tool before making any adjustments or removing or installing accessories. Before reconnecting the • Two front positions: Forward handle positions are designed for optimized balance in surface finishing applications. tool, depress and release the trigger switch to ensure that the tool is off. 1. Remove the four corner screws attaching the gear case to motor housing. 8