Dewalt D28494N Instruction Manual - Page 9
Accessories and Attachments, Sanding Flap Discs - grinder
View all Dewalt D28494N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
399080-02 rev 11/15/02 10:13 AM Page 5 English MULTIPLE SIDE HANDLE POSITIONS The side handle can be properly positioned in five locations based on personal preference and application. The side handle must be used at all times to maintain proper control of the tool. RUBBER BUMPER The gear case rubber bumper may wear with use. The bumper can be replaced with part number 397711-00 available at extra cost from DEWALT authorized service centers. Replacement should be performed by DEWALT authorized service centers or qualified service personnel. SPINDLE LOCK C The spindle lock pin is provided to prevent the spindle from rotating when installing or removing wheels. Operate the spindle lock pin only when the tool is turned off and unplugged from the power source. To engage the lock, depress the spindle lock button (C) and rotate the spindle until you are unable to rotate it further. CAUTION: Never depress the spindle lock button while the grinder is running. Never turn on the grinder while the spindle lock button is depressed. Damage to your tool or personal injury may result. SOFT MOUNT The grinder is equipped with a soft mount, enabling easy wheel installation and removal. Accessories and Attachments It is important to choose the correct guards, backing pads and flanges to use with grinder accessories. See the chart on pages 5-7 for information on choosing the correct accessories. Sanding Flap Discs soft mount soft mount Type 27 guard D284937/D284939 Type 27 guard D284937/D284939 hubbed sanding flap disc backing flange 54339-00 non-hubbed sanding flap disc clamp nut 22191-00 NOTE: Wheel size must match guard size; i.e., a new 7" wheel may not be used with a 9" guard. The bottom surface of wheel must be inside the bend of the guard lip. 5