Dewalt DCCS670X1 Instruction Manual - Page 13
Saw Chain and Guide Bar Oiling Fig.
View all Dewalt DCCS670X1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Replacing the Saw Chain (Fig. A, H) CAUTION: Sharp chain. Always wear protective gloves when handling the chain. The chain is sharp and can cut you when it is not running. WARNING: Sharp moving chain. To prevent accidental operation, ensure that battery is removed from the tool before performing the following operations. Failure to do this could result in serious personal injury. • Flip up locking tab and rotate the bar adjust locking knob 8 counterclockwise to release chain tension. • Remove sprocket cover 6 as described in Installing the Guide Bar and Saw Chain section. • Lift the worn saw chain 5 out of the groove in the guide bar 4 . • Place the new chain in the slot of the guide bar, making sure the saw teeth are facing the correct direction by matching the arrow on the chain with the graphic on the sprocket cover 6 shown in Figure H. • Follow instructions for Installing the Guide Bar and Saw Chain. Fig. H English the reservoir with the recommended bar and chain oil until the oil level has reached the top of the oil level indicator 10 . • Refit the oil cap and tighten clockwise a quarter turn. Flip up locking lever to its locked position. • Periodically switch the chain saw off and check the oil level indicator to ensure the bar and chain are being properly oiled. Fig. L 10 16 Transporting Saw (Fig. A, J) • Always remove the battery from the tool and cover the guide bar 4 with the scabbard 11 (see Figure J) when transporting the saw. • Engage chain brake by pushing chain brake / front hand guard 3 forward. Fig. J Replacement chain and bar are available from your nearest DeWALT service center. • DCCS670 requires replacement chain # DWRC1600, service part number 90618541. Replacement 16" bar, service part number 90618542. Saw Chain and Guide Bar Oiling (Fig. I) Auto Oiling System This chain saw is equipped with an auto oiling system that keeps the saw chain and guide bar constantly lubricated. The oil level indicator 10 shows the level of the oil in the chain saw. If the oil level is less than a quarter full, remove the battery from the chain saw and refill with the correct type of oil. Always empty oil tank when finished cutting. NOTE: Use a high quality bar and chain oil for proper chain and bar lubrication. As a temporary substitute, a nondetergent SAE30 weight motor oil can be used. The use of a vegetable based bar and chain oil is recommended when pruning trees. Mineral oil is not recommended because it may harm trees. Never use waste oil or very thick oil. These may damage your chainsaw. Filling the Oil Reservoir • Flip down locking lever and unscrew counterclockwise a quarter turn and then remove the oil cap 16 . Fill OPERATION WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery pack before making any adjustments or removing/ installing attachments or accessories. An accidental start-up can cause injury. Installing and Removing the Battery Pack (Fig. K, L) NOTE: For best results, make sure your battery pack is fully charged. To Install the Battery Pack into the Tool 1. Align the battery pack 7 with the rails inside the tool (see Figure K). 2. Slide it into the tool until the battery pack is firmly seated and ensure that you hear the lock snap into place. To Remove the Battery Pack from the Tool 1. Press the release button 15 and firmly pull the battery pack out of the tool handle (see Figure L). 2. Insert battery pack into the charger as described in the charger section of this manual. 11