Dewalt DCL077B Instructional Manual - Type 1 - Page 4

Warning

Page 4 highlights

English 12V/20V Max* Compact Task Light DCL077 IMPORTANT SAFETY INSTRUCTIONS WARNING: When using the light, basic precautions should always be followed, including the following: a ) Read all the instructions before using the light. b ) To reduce the risk of injury, close supervision is necessary when a light is used near children. c ) To reduce the risk of electrical shock, do not put light in water or other liquid. Do not place or store light where it can fall or be pulled into a tub or sink. d ) Only use attachments recommended or sold by the manufacturer. e ) Turn the light off when not in use. f ) Do not operate any light after it malfunctions or is dropped or damaged in any manner. Return light to the nearest authorized service facility for examination, repair, or electrical or mechanical adjustment. g ) Use only the charger supplied by the manufacturer to recharge. SAVE THESE INSTRUCTIONS Specific Safety Rules for Lights WARNING: Do not place the light in a position which may cause anyone to intentionally or unintentionally stare into the light. Serious eye injury could result. WARNING: Fire hazard. Do not operate light or charger near flammable liquids or in gaseous or explosive atmospheres. Internal sparks may ignite fumes causing personal injury. Additional Safety Rules for Lights WARNING: To reduce the risk of fire, do not place anything on top of the lens during or after operation of the light. CAUTION: Only use light on stable surface. Do not raise above work space/personnel via lifting, hoisting, mounting, or suspension. • Risk of electric shock. Do not expose to rain. Store indoors. • Do not submerge light in any liquid. • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. • Before using battery and light, read all instructions and cautionary markings on area light, charger and battery pack. 2 • Store the light indoors when not in use. Keep out of reach of children. • Place the light away from any heat source. • Do not disassemble light. Take it to an authorized service center when service or repair is required. Incorrect reassembly may result in a risk of electric shock, electrocution or fire. The label on your tool may include the following symbols. The symbols and their definitions are as follows: V volts or AC/DC..... alternating or Hz hertz direct current min minutes Class II or DC....... direct current Construction Class I Construction (double insulated) (grounded) no no load speed .../min per minute n rated speed BPM beats per minute earthing terminal IPM impacts per minute RPM revolutions per safety alert symbol visible radiation minute avoid staring at sfpm surface feet per minute SPM strokes per minute light wear respiratory protection OPM oscillations per minute A amperes W watts or AC alternating current wear eye protection wear hearing protection read all documentation IPXX IP symbol BATTERIES AND CHARGERS The battery pack is not fully charged out of the carton. Before using the battery pack and charger, read the safety instructions below and then follow charging procedures outlined. When ordering replacement battery packs, be sure to include the catalog number and voltage. READ ALL INSTRUCTIONS Important Safety Instructions for All Battery Packs WARNING: Read all safety warnings, instructions, and cautionary markings for the battery pack, charger and product. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. • Do not charge or use the battery pack in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Inserting or removing the battery pack from the charger may ignite the dust or fumes. • When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys,

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

ENGLISH
2
READ ALL INSTRUCTIONS
Important Safety Instructions for All
Battery Packs
±
WARNING:
Read all safety warnings,
instructions, and cautionary markings for the
battery pack, charger and product. Failure to
follow the warnings and instructions may result
in electric shock, fire and/or serious injury.
Do not charge or use the battery pack in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust.
Inserting or removing the battery
pack from the charger may ignite the dust or fumes.
When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
procedures outlined. When ordering replacement battery
packs, be sure to include the catalog number and voltage.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V
.........................
volts
Hz
.......................
hertz
min
.....................
minutes
or DC
......
direct current
......................
Class I Construction
(grounded)
…/min
..............
per minute
BPM
....................
beats per minute
IPM
.....................
impacts per minute
RPM
....................
revolutions per
minute
sfpm
...................
surface feet per
minute
SPM
....................
strokes per minute
OPM
....................
oscillations per
minute
A
.........................
amperes
W
........................
watts
or AC
...........
alternating current
or AC/DC
....
alternating or
direct current
......................
Class II
Construction
(double insulated)
n
o
.......................
no load speed
n
.........................
rated speed
......................
earthing terminal
.....................
safety alert symbol
.....................
visible radiation
.....................
avoid staring at
light
.....................
wear respiratory
protection
.....................
wear eye
protection
.....................
wear hearing
protection
.....................
read all
documentation
IPXX
....................
IP symbol
Additional Safety Rules for Lights
±
WARNING:
To reduce the risk of fire, do not place
anything on top of the lens during or after operation
of the light.
±
CAUTION:
Only use light on stable surface. Do not
raise above work space/personnel via lifting, hoisting,
mounting, or suspension.
Risk of electric shock. Do not expose to rain.
Store indoors.
Do not submerge light in any liquid.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
Before using battery and light, read all instructions
and cautionary markings on area light, charger and
battery pack.
Specific Safety Rules for Lights
±
WARNING:
Do not place the light in a position
which may cause anyone to intentionally or
unintentionally stare into the light.
Serious eye
injury could result.
±
WARNING:
Fire hazard.
Do not operate light or
charger near flammable liquids or in gaseous or
explosive atmospheres. Internal sparks may ignite
fumes causing personal injury.
IMPORTANT SAFETY INSTRUCTIONS
±
WARNING:
When using the light, basic
precautions should always be followed, including
the following:
a )
Read all the instructions before using
the light.
b )
To reduce the risk of injury, close supervision is
necessary when a light is used near children.
c )
To reduce the risk of electrical shock, do not put
light in water or other liquid.
Do not place or store
light where it can fall or be pulled into a tub or sink.
d )
Only use attachments recommended or sold by
the manufacturer.
e )
Turn the light off when not in use.
f )
Do not operate any light after it malfunctions
or is dropped or damaged in any manner.
Return light to the nearest authorized service
facility for examination, repair, or electrical or
mechanical  adjustment.
g )
Use only the charger supplied by the
manufacturer to recharge.
SAVE THESE INSTRUCTIONS
12V/20V Max* Compact Task Light
DCL077
Store the light indoors when not in use.
Keep out of
reach of children.
Place the light away from any heat source.
Do not disassemble
light.
Take it to an authorized
service center when service or repair is required. Incorrect
reassembly may result in a risk of electric shock,
electrocution or fire.