Dewalt DCN650B Instruction Manual - Page 14

English Fig. J 15 7. Reinsert nails into magazine (see Loading the Tool) 8. Reinsert battery pack. NOTE: The tool will disable itself and not reset until the battery pack has been removed and reinserted. NOTE: Should nails continue to jam frequently in nosepiece, have tool serviced by an authorized DeWALT service center. Fig. L 5 3 Headlights (Fig. K) There is a headlight 4 located on each side of the nailer. Headlights turn on upon battery insertion, activation of the trigger, or depressing the contact trip. The lights will automatically shut off after 20 seconds unless tool remains in use. NOTE: These headlights are for lighting the immediate work surface and are not intended to be used as flashlights. LOW BATTERY INDICATOR: The left-side headlight will flash four consecutive times and then shut down to indicate low battery. JAMMED NAIL INDICATOR: The right-side headlight will flash continually if a nail becomes jammed in the nosepiece (see Clearing a Jammed Nail). Fig. K 4 Clearing a Jammed Nail (Fig. L) If a nail becomes jammed in the nosepiece, keep the tool pointed away from you and follow these instructions to clear: 1. Remove battery pack from tool and engage the trigger lock-off. 2. Pull the pusher back and remove any loaded nails. 3. Lift the jam clear latch 5 then pull up to open the nosepiece door. 4. Remove bent nail, using pliers if necessary. 5. If driver blade is in the down position, cycle the stall release lever 15 using enough force to fully slide it to the other end of the slot in the housings. 6. Close the nosepiece door 18 and engage the latch pin 17 under the two arms 19 on the nosepiece. Push latch until it locks in place. 18 17 19 Cold Weather Operation When operating tools at temperatures below freezing: 1. Keep tool as warm as possible prior to use. 2. Actuate the tool 5 or 6 times into scrap lumber before using. Hot Weather Operation Tool should operate normally. However, keep tool out of direct sunlight as excessive heat can deteriorate bumpers and other rubber parts resulting in increased maintenance. MAINTENANCE WARNING: To reduce the risk of serious personal injury, turn unit off and remove the battery pack before making any adjustments or removing/ installing attachments or accessories. An accidental start-up can cause injury. Cleaning WARNING: Blow dirt and dust out of all air vents with clean, dry air at least once a week. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection when performing this. WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. 12