Dewalt DW03601 Instruction Manual - Page 12

E The Laser Beams Flash Service and Repairs When in self-leveling mode, the laser is designed to self-level up to an average of 4° in all directions. If the laser is tilted so much that the internal mechanism cannot level itself, the laser beams will flash indicating that the tilt range has been exceeded. THE FLASHING BEAMS CREATED BY THE LASER ARE NOT LEVEL OR PLUMB AND SHOULD NOT BE USED FOR DETERMINING OR MARKING LEVEL OR PLUMB. Try repositioning the laser on a more level surface. Note: Disassembling the laser level will void all warranties on the product. To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be performed by authorized service centers. Service or maintenance performed by unqualified personnel may result in a risk of injury. To locate your nearest Stanley service center, go to http://www.DEWALT.com. The Laser Beams Will Not Stop Moving The laser is a precision instrument. Therefore, if it is not positioned on a stable (and motionless) surface, the laser will continue to try to find level. If the beams will not stop moving, try placing the laser on a more stable surface. Also, try to make sure that the surface is relatively flat and level, so that the laser is stable. Specifications Light Source Laser Wavelength Laser Power Working Range Accuracy Power Source Operating Temperature Storage Temperature Environmental DW03601 DW03601CG Laser diodes 630 - 680 nm visible 510 - 530 nm visible ≤3.2 mW CLASS 2 LASER PRODUCT 33′ (10m) 50′ (15m) ±0.16" @ 33′ (±4 mm @ 10m) 4 AA (1.5V) size batteries (6V DC) 14°F to 104°F (-10°C to 40°C) -5°F to 140°F (-20°C to 60°C) Water & Dust Resistant to IP54 12