Dewalt DW325C Instruction Manual - Page 4
English - nails
View all Dewalt DW325C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
English • Only use air hose that is rated for a maximum working pressure of at least 150 PSI (10.3 BAR) or 150% of the maximum system pressure, which ever is greater. (Fig. D) • Do not use bottled gases to power this tool. Bottled compressed gases such as FIG. E oxygen, carbon dioxide, nitrogen, hydrogen, propane, acetylene or air are not for use with pneumatic tools. Never use combustible gases or any other reactive gas as a power source for this tool. Danger of explosion and/or serious personal injury may result. (Fig. E) • Use couplings that relieve all pressure FIG. F from the tool when it is disconnected from the power supply. Use hose connectors that shut off air supply from compressor when the tool is disconnected. (Fig. F) • Disconnect tool from air supply when not in use. Always disconnect tool from air supply and remove fasteners FIG. G from magazine before leaving the area or passing the tool to another operator. Do not carry tool to another work area in which changing location involves the use of scaffoldings, stairs, ladders, and the like, with air supply connected. Do not make adjustments, remove magazine, perform maintenance or clear jammed fasteners while connected to the air supply. If the contact trip is adjusted when the tool is connected to the air supply and nails are loaded, accidental discharge may occur. (Fig. G) • Connect tool to air supply before loading fasteners, to prevent a fastener from being fired during connection. The tool driving mechanism may cycle when tool is connected to the air supply. Do not load fasteners with trigger or contact trip depressed, to prevent unintentional firing of a fastener. • Do not remove, tamper with, or otherwise cause the tool, trigger, or FIG. H contact trip to become inoperable. Do not tape or tie trigger or contact trip in the on position. Do not remove spring from contact trip. Make daily inspections for free movement of trigger and contact trip. Uncontrolled discharge could result. • Inspect tool before use. Do not operate a tool if any portion of the tool, FIG. I trigger, or contact trip is inoperable, disconnected, altered, or not working properly. Leaking air, damaged parts or missing parts should be repaired or replaced before use. (Fig. H) • Do not alter or modify the tool in any way. (Fig. I) • Always assume that the tool contains FIG. J fasteners. • Do not point the tool at co-workers or yourself at any time. No horseplay! Work safe! Respect the tool as a working implement. (Fig. J) 2