Dewalt DWE4120 Instruction Manual - Page 11
Rotating the Gear Case, Fig. 3 - service center
View all Dewalt DWE4120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
4-1/2" (114.3 mm) Grinding Wheels Wire Wheels English Type 27 guard backing flange Type 27 depressed center wheel Type 27 guard Type 27 hubbed wheel threaded clamp nut FIG. 2 C ATTACHING SIDE HANDLE (FIG. 2) The side handle (C) can be fitted to either side of the gear case in the threaded holes, as shown. Before using the tool, check that the handle is tightened securely. Use a wrench to firmly tighten the side handle. Type 27 guard Type 27 guard 3" (76.2 mm) wire cup brush 4" (101.6 mm) wire wheel Rotating the Gear Case FIG. 3 (Fig. 3) 1. Remove the four corner screws attaching the gear case to motor housing. 2. Without separating the gear case from 90˚ 90˚ motor housing, rotate the gear case head to desired position. NOTE: If the gear case and motor housing become separated by more than 1/8" (3.17 mm), the tool must be serviced and re-assembled by a DEWALT service center. Failure to have the tool serviced may cause brush, motor and bearing failure. 3. Reinstall screws to attach the gear case to the motor housing. Tighten screws to 18 in.-lbs. torque. Overtightening could cause screws to strip. 9