Dewalt DWE46202 Instruction Manual 1 - Page 9

2. Rotate the shroud into the desired working position. The shroud should be positioned between the spindle and the operator to provide optimum efficiency. 3. Tighten the collar screw 11 to secure the tuckpoint shroud on the gear case. Do not operate the grinder with a loose tuckpoint shroud. 4. To remove the tuckpoint shroud, loosen the collar screw, rotate the tuckpoint shroud to align the slots and tabs and pull up on the tuckpoint shroud. NOTE: The tuckpoint shroud is pre-adjusted to the diameter of the gear case hub at the factory. If, after a period of time, the tuckpoint shroud becomes loose, tighten the collar screw 11 . NOTICE: If tuckpoint shroud cannot be secured by tightening the collar screw, do not use tool. Take the tool and tuckpoint shroud to a service center to repair or replace the tuckpoint shroud. Flanges and Wheels CAUTION: Turn unit off and unplug the tool before making any adjustments or removing or installing attachments or accessories. Mounting Non-Hubbed Wheels (Fig. C) WARNING: Failure to properly seat the flanges and/or wheel could result in serious injury (or damage to the tool or wheel). WARNING: A closed, two-sided cutting wheel guard is  required when using diamond coated cutting wheels. WARNING: Use of a damaged flange or guard or failure to use proper flange and guard can re­sult in injury due to wheel breakage and/or wheel contact. See the Accessories Chart for more information. It may be necessary to open the cornering door to install tuckpointing wheels, see Cornering Door Application. 1. Place the tool on a table, guard up. 2. Install the unthreaded backing flange 3 on spindle 1 with the raised center (pilot) facing the wheel. 3. Place wheel 17 against the backing flange, centering the wheel on the raised center (pilot) of the backing flange. 4. While depressing the spindle lock button and with the hex depressions facing away from the wheel, thread the threaded locking flange 4 on spindle so that the lugs engage the two slots in the spindle. 5. While depressing the spindle lock button, tighten the threaded locking flange 4 using a Hex wrench. 6. To remove the wheel, depress the spindle lock button and loosen the threaded locking flange. English Fig. C 4 17 3 1 Depth of Cut Adjustment (Fig. D) 1. Loosen the depth of cut shoe locking knob 13 . 2. Slide the depth of cut shoe 12 to the desired position. 3. Tighten depth of cut shoe locking knob. Fig. D 12 13 Corner Door Application (Fig. E) WARNING: To reduce the risk of injury, ALWAYS turn off tool and disconnect the tool from the power source before making any adjustments or removing or installing attachments or accessories. This applies to both the grinder and the dust extractor vacuum. Such preventative safety measures reduce the risk of starting the tool accidentally. WARNING: Risk of personal injury. The corner door should only be opened for cutting inside corners. Keep hands and body away from cutting area at all times. Ensure corner door is closed in all other applications. This feature allows the cutting of an inside corner. 1. Ensure the tool is off and wheel has come to a complete stop. 2. Turn cornering door locking lever 14 counterclockwise one full rotation. Grasp the corner door 9 and rotate open as shown in Figure E. 3. Place hands away from the wheel area and position yourself so the open underside of the shroud is facing away from you. 4. Turn the tool on and allow the tool to reach full speed before touching the tool to the work surface. 7