Dewalt DWFP55120 Instruction Manual - Page 8

Save These Instructions, For Future Use, Features

Get Dewalt DWFP55120 PDF manuals and user guides View all Dewalt DWFP55120 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

English Fig. 1 D C B A H F • Under some conditions and • Always wear proper hearing duration of use, noise from protection during use. this product may contribute to hearing loss. SAVE THESE INSTRUCTIONS FOR FUTURE USE FEATURES ON (I) /OFF SWITCH (O) E Place this switch (A) in the ON position to provide automatic power to the pressure switch and OFF to remove power at the end of each A use. PRESSURE SWITCH (NOT SHOWN) The pressure switch automatically starts the motor when the air tank pressure drops below the factory set cut-in pressure. It stops the motor when the air tank pressure reaches the factory set cut‑out pressure. SAFETY VALVE If the pressure switch does not shut off the air G compressor at its cut-out pressure setting, the safety valve (E) will protect against high pressure by popping out at its factory set pressure (slightly higher than the pressure switch cut-out setting). E CHECK VALVE 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
8
English
• Under some conditions and
duration of use, noise from
this product may contribute
to hearing loss.
• Always wear proper hearing
protection during use.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
FEATURES
ON (I) /OFF SWITCH (O)
A
Place this switch (A) in the ON position to
provide automatic power to the pressure switch
and OFF to remove power at the end of each
use.
PRESSURE SWITCH (NOT SHOWN)
The pressure switch automatically starts the motor when the air
tank pressure drops below the factory set
cut-in
pressure. It stops
the motor when the air tank pressure reaches the factory set
cut-out
pressure.
SAFETY VALVE
If the pressure switch does not shut off the air
E
compressor at its cut-out pressure setting, the
safety valve (E) will protect against high
pressure by popping out at its factory set
pressure (slightly higher than the pressure
switch cut-out setting).
CHECK VALVE
C
D
B
H
F
G
E
Fig. 1
A