Dewalt DWS713 Instruction Manual - Page 12

English BEVEL SETTING TYPE OF CUT LEFT SIDE, INSIDE CORNER 33.9° 1. Top of molding against fence 2. Miter table set right 31.6° 3. Save left end of cut RIGHT SIDE, INSIDE CORNER 33.9° 1. Bottom of molding against fence 2. Miter table set left 31.6° 3. Save left end of cut LEFT SIDE, OUTSIDE CORNER 33.9° 1. Bottom of molding against fence 2. Miter table set left 31.6° 3. Save right end of cut RIGHT SIDE, OUTSIDE CORNER 1. Top of molding against fence 33.9° 2. Miter table set right 31.6° 3. Save right end of cut When setting bevel and miter angles for all compound miters, remember that: The angles presented for crown moldings are very precise and difficult to set exactly. Since they can easily shift slightly and very few rooms have exactly square corners, all settings should be tested on scrap molding. PRETESTING WITH SCRAP MATERIAL IS EXTREME­LY IMPORTANT! Alternative Method for Cutting Crown Molding (Fig. U) Place the molding on the table at an angle between the fence 10 and the saw table 34 , as shown in Figure U. Use of the crown molding fence accessory (DW7084) is highly recommended because of its degree of accuracy and convenience. The crown molding fence accessory is available at extra cost from your local dealer. The advantage to cutting crown molding using this method is that no bevel cut is required. Minute changes in the miter angle can be made without affecting the bevel angle. This way, when corners other than 90° are encountered, the saw can be quickly and easily adjusted for them. Use the crown molding fence accessory (DW7084) to maintain the angle at which the molding will be on the wall. Fig. U 34 10 Fig. V 10 Fig. W 23 RIGHT 10 23 WRONG Bowed Material (Fig. X, Y) When cutting bowed material always position it as shown in Figure X and never like that shown in Figure Y. Positioning the material incorrectly will cause it to pinch the blade near the completion of the cut. Fig. X Instructions for Cutting Crown Molding Angled Between the Fence and Base of the Saw for All Cuts 1. Angle the molding so the bottom of the molding (part which goes against the wall when installed) is against the fence and the top of the molding is resting on the base of the saw, as shown in Figure U. 2. The angled "flats" on the back of the molding must rest squarely on the fence and base of the saw. Inside corner Outside corner Left side 1. Miter right 45° 2. Save right side of cut 1. Miter left 45° 2. Save right side of cut Fig. Y Right side 1. Miter left 45° 2. Save left side of cut 1. Miter right 45° 2. Save left side of cut Special Cuts NEVER MAKE ANY CUT UNLESS THE MATERIAL IS SECURED ON THE TABLE AND AGAINST THE FENCE. Aluminum Cutting (Fig, A, V, W) ALWAYS USE THE APPROPRIATE SAW BLADE MADE ESPECIALLY FOR CUTTING ALUMINUM. These are available at your local DeWALT retailer or DeWALT service center. Certain workpieces, due to their size, shape or surface finish, may require the use of a clamp or fixture to prevent movement during the cut. Position the material so that you will be cutting the thinnest cross section, as shown in Figure V. Figure W illustrates the wrong way to cut these extrusions. Use a stick wax cutting lubricant when cutting aluminum. Apply the stick wax directly to the saw blade 23 before cutting. Never apply stick wax to a moving blade. The wax, available at most hardware stores and industrial mill supply houses, provides proper lubrication and keeps chips from adhering to the blade. Be sure to properly secure workpiece. Refer to Saw Blades under Accessories for correct saw blade. 10