Dewalt DWV012 Instruction Manual - Page 9
To Shut Down Fig. 1, MAINTENANCE, Filter Fig. 1, 10, 11, Cleaning
View all Dewalt DWV012 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
TELESCOPING HANDLE (FIG. 1, 9) FIG. 9 NOTE: Use care to not damage filter material. 4. Inspect filters for wear, tears or other damage. Press release button (Q) to raise and lower the telescoping handle (P). NOTE: If there is any doubt on the condition of the filters they MUST be replaced. DO NOT continue use if filters are damaged. English To Shut Down (Fig. 1) 1. Turn on/off/tool control switch P (O) to the OFF position (O). 2. Unplug the unit. Q MAINTENANCE WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury. Filter (Fig. 1, 10, 11) FILTER CARE The HEPA filters included with this vacuum are long life filters. To WARNING: Never use compressed air or a brush to clean filters, otherwise damage to the filter membrane will occur which will allow dust to pass through the filter. If needed, gently tap against a hard surface or rinse with room temperature water and let air dry. Cleaning of the filters is typically unnecessary. Even if the filter is covered with dust, the automatic filter cleaning system will maintain maximum performance and continue to function. If visual damage to the filter membrane exists, replace filters. Filters typically last between six and twelve months, depending on use and care. To Install Filters 1. Ensure filter seal (X) is in place and is secure FIG. 11 W X be effective in minimizing dust recirculation, especially in lead paint (EPA RRP Rule) applications, the filters MUST be installed correctly and in good condition. To Remove Filters 1. Turn on/off/tool control switch (O) to the OFF position (O) and unplug cord from outlet. 2. Release canister latches (D) and remove vacuum head (C) from canister. Place vacuum head on a FIG. 10 I 2. Line up filter threads (W) to vacuum head threads and using moderate force, turn filter clockwise until tight. NOTE: Use care to not damage filter material. 3. Place the vacuum head (C) onto the container and secure it by closing the canister latches (D). level surface upside down. 3. Turn each filter (I) counterclockwise by gripping it on the plastic end cover as shown, and carefully remove from head, ensuring debris does not fall into mounting hole. Cleaning WARNING: Blow dirt and dust out of all air vents with dry air at least once a week. Wear proper ANSI Z87.1 (CAN/CSA Z94.3) eye protection and proper NIOSH/OSHA/MSHA respiratory protection when performing this. 7