Dewalt DXCMV5048055 Instruction Manual - Page 16
Shut-down Fig. 1
View all Dewalt DXCMV5048055 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
English tered air at an item that could be damaged by moisture. Some air tools and accessories may require filtered air. Read the ins tructions for the air tools and accessories. How to Start 1. Turn the Auto/Off switch to "Auto" and allow tank pressure to build. Motor will stop when tank pressure reaches "cut-out" pressure. 2. Pull the regulator knob out and turn clockwise to increase pressure. When the desired pressure is reached push knob in to lock in place. IMPORTANT: When using regulator and other accessories refer to the manufacturers instructions. WARNING: Risk of bursting. If any unusual noise or vibration is noticed, stop the compressor immediately and have it checked by a trained service technician. The compressor is ready for use. Shut-down (Fig. 1) 1. Move Auto/Off switch to the OFF position. NOTE: If finished using compressor, follow Steps 2 - 6. 2. Pull the regulator knob out and turn counterclockwise until fully closed. Ensure regulated pressure gauge reads 0 psi. Push knob in to lock in place. 3. Remove hose and accessory. WARNING: Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip. 4. Drain the air tank, see Draining Air Tank under Maintenance. Ensure air tank pressure gauge reads 0 psi. WARNING: Risk of bursting. Drain air tank daily. Water will condense in air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture. 5. Allow the compressor to cool down. 6. Wipe air compressor clean and store in a safe, non-freezing area. FIG. 3 OFF AUTO OPEN CLOSE 16