Dirt Devil M0896RED Revision 1 (3/2002) - Page 2
Required: Screwdriver And Drill - filters
View all Dirt Devil M0896RED manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
TOOL REQUIRED: SCREWDRIVERAND DRILL A. CHARGINGISTORAGE BASE Designed to sit in the charging base on a flat surface (Diagram 1) or mount vertically (Diagram 2). For tidy storage, wrap excess cord on the back of the charging base and exit at either side or out the bottom. TO WALL MOUNT: 1. Place charging base against the mounting surface. Mark the centers of the holes. 2. Move base, then drill a 3/16 hole through the center of the marks. 3. Push plastic wall anchor into the drilled hole. 4. Be sure marked location is correct before drilling the second hole (adjust if necessary). Drill second hole and install other wall anchor. Sits on a flat surface. 5. Match up holes in storage base to wall anchors and insert screws. Be sure cord exits from one of the cord slots on the storage base 6. T~ghtenthe screws to hold the base flush to the mountlng surface B. UNlT STORAGE , , 1 *. jj.j,, , 1. Hold the unit by the handle and push down firmly onto the charging base. 2. Be sure the red charging light is on. C. CHARGING NOTE: Use only the charger supplied by the manufacturer to recharge. IMPORTANT: BEFORE FIRST USE, CHARGE YOUR UNlT FOR AT LEAST 24 HOURS. Power switch must be in the OFF position. Keep the charger plugged into a standard outlet at all times. It is normal for Sits vertically or mounts on the charger to become warm to the touch when charging. the wall. If the operating time gets shorter after repeated use, let the unit run until it stops running. Recharge for 24 hours and repeat monthly for best results. TO USE: Slide the power switch to the ON position. TO TURN UNlT OFF: Slide the power switch to the OFF position. Empty and clean the unit and filter after each use or after large pickups when the unit becomes full. The crevice tool is permanently stored on board. It is located on the to^ of the dust CUD. for v.our convenience. TO USE TO STORE Press the crevice tool release button. Flip crevice tool down to line up with nozzle then press up until secure in place. RETRACTABLE BRISTLES Ideal for cleaning delicate surfaces. To use: slide the switch underneath dirt container forward. Slide switch back to retract bristles. To store crevice tool: Pull down until loose. Flip crevice tool up towards unit and you feel it lock into place. For filter replacement part # 3-089570-001, please call 1-800-321-1134. Depress the dirt cup release button and pull nozzle away from unit. Hold nozzle over a wastebasket. Grasp filter and gently pull out. For filter replacement call 1-800321-1134. Shake excess dirt and debris out of dust cup. Brush the dust and dirt off the filter, or shake the filter inside of the wastebasket. IMPORTANT: DO NOT WASH FILTER.