Dynex DX-P9DVD11 User Manual (English) - Page 16

16 Specifications Specifications subject to change without notice. Compatible discs Signal system LCD Frequency response Audio S/N Laser Wave length Power source Operating temperature Weight Dimensions (W × D × H) Battery DVDs and CDs NTSC DX-P7DVD11 - 7 inches DX-P9DVD11 - 9 inches 20 Hz to 20 kHz Better than 60 dB Semiconductor 650 nm/795 nm DC 9 V-12 V 41° to 95°F (5° to 35°C) DX-P7DVD11 - 1.54 lbs. (0.7 kg) DX-P9DVD11 - 2.42 lbs. (1.1 kg) DX-P7DVD11 - 7.67 x 6.06 x 1.46 inches (195 x 154 x 37 mm) DX-P9DVD11 - 9.45 x 7.01 x 1.857 inches (240 x 178 x 40 mm) Li-polymer Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC warning Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user's authority to operate this equipment.