Dyson DC23 User Guide - Page 10

SAVE THESE INSTRUCTIONS THIS APPLIANCE IS INTENDED FOR HOUSEHOLD USE ONLY Caution Do not allow the vacuum cleaner to be used by anyone who may not be able to operate it safely. Consult your flooring manufacturer's recommended instructions before vacuuming and caring for your flooring, rugs and carpets. Some carpets will fuzz if a rotating brushbar is used when vacuuming. If this happens, we recommend vacuuming in bare floors mode and consulting with your flooring manufacturer. The brushbar will reset to 'ON' each time you start the machine and put it in the cleaning position. This appliance is designed for domestic indoor and car use only; it should not be used or stored outdoors. It should not be used for commercial or rental purposes. Do not use your vacuum cleaner outdoors or on wet surfaces, or to vacuum water or other liquids - electric shock or personal injury could occur. The vacuum cleaner may be used inside a garage only with the Model 08909 Dyson Car Cleaning Kit accessories. If used in a garage, care should be taken to wipe the soleplate and wheels with a dry cloth after vacuuming to clean off any sand, dirt or pebbles which could damage delicate floors. If the cable is damaged, turn power off and disconnect from the socket outlet immediately. The cable must only be replaced by Dyson or our appointed service agent to avoid a hazard. Take extra care when vacuuming on stairs; always work with the vacuum cleaner at the bottom of the stairs. Keep the vacuum cleaner on the floor. Do not put the vacuum cleaner on chairs, tables etc. The use of an extension cable is not recommended. Do not lubricate any parts, or carry out any maintenance or repair work other than that shown in this manual, or as advised by the Dyson Helpline. If the vacuum cleaner is not functioning properly, has been dropped, damaged, left outdoors, or immersed in liquid, contact the Dyson Helpline. Check to ensure your electricity supply corresponds to that shown on the rating plate which can be found behind the clear binTM. The vacuum cleaner must only be used as rated. Switch off and unplug the vacuum cleaner before changing accessories, removing the clear binTM, filters, hose, checking for blockages or before performing any other maintenance operation. Ensure that the washable filter is completely dry before refitting into the vacuum cleaner. Fine dust such as plaster dust or flour should only be vacuumed in very small amounts. Do not press the cyclone release button while carrying the machine or it could fall and cause injury. Do not use the machine to pick up sharp hard objects, small toys, pins, paper clips etc., because they may damage the machine. When vacuuming, certain carpets may generate small static charges in the clear binTM or wand. These are not associated with the electricity supply. To minimize any effect from this, do not put your hand or insert any object into the clear binTM unless you have first emptied it and rinsed it out with cold water. This machine is fitted with an automatically resetting thermal cut-out. If the machine overheats it will cut-out, it must be switched off and unplugged immediately and allowed to cool down before attempting to check filters or for blockages. Emptying the Clear binTM Empty the clear binTM as soon as the MAX mark level is reached. Turn power off and unplug before emptying the clear binTM. Do not use the machine without the clear binTM in place. Failure to do so could result in electric shock or personal injury. Emptying inside a bag is recommended for allergy sufferers. Cleaning the Clear binTM Do not use detergents, polishes or air fresheners to clean the clear binTM. Do not immerse the whole cyclone in water. Ensure clear binTM is completely dry before re-fitting. Clean the shroud with a cloth or dry brush to remove lint and dust. Do not put the clear binTM in a dishwasher.