E-Z-GO Terrain 250 - Gas Owner Manual - Page 50

Light Bulb Replacement, Fuse Replacement, Vehicle With A Discharged Battery

Get E-Z-GO Terrain 250 - Gas PDF manuals and user guides View all E-Z-GO Terrain 250 - Gas manuals
Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

MAINTENANCE Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers. Light Bulb Replacement To reduce the possibility of premature bulb failure, do not touch new bulbs with bare fingers. Use clean, dry tissue or paper towel to handle the glass portion of the bulb. For vehicles equipped with lights mounted in the cowl, locate bulb socket on backside of light and turn bulb socket a quarter turn counterclockwise to unlock and pull out bulb and socket. Insert new bulb and rotate socket a 5 quarter turn clockwise to secure. Similarly replace the turn signal light bulb, locate bulb socket on backside of light bar and turn bulb socket a quarter turn counterclockwise to unlock and pull out bulb and socket. Insert new bulb and rotate socket a quarter turn clockwise to secure.. To replace the tail and brake light bulb, roll the rubber bezel from around the edge of the taillight and remove lens. Install replacement bulb and replace lens. Inside of Cowl Headlight Casing Screw Headlight Bulb Fuse Replacement To replace fuses, locate the fuse block under the driver side seat. Pull out old fuse and replace with a new automotive type fuse. Headlight and taillight bulbs and fuses are available from a local Distributor, an authorized Branch or the Service Parts Department. Vehicle With A Discharged Battery To reduce the possibility of severe injury or death from inadvertent motion, do not attempt to 'jump start' a vehicle. The vehicle is equipped with a starter/generator and does not idle. When starting the engine, the starter/generator functions as a starter and with the engine running, it functions as a generator. With the short running times associated with this kind of vehicle, the generator is more than adequate to maintain the battery charge level. The generator is not designed to charge a discharged battery. When engine starts, the clutches engage and cause vehicle to move making 'jump starting' both dangerous and impractical. If the vehicle battery has become discharged, it must be charged using a 12 volt charger that is rated at 10 amps or less. Read and understand all instructions provided by the manufacturer of the charger. 5- 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
5 -
8
5
Light Bulb Replacement
To reduce the possibility of premature bulb failure, do
not touch new bulbs with bare fingers. Use clean, dry
tissue or paper towel to handle the glass portion of the
bulb.
For vehicles equipped with lights mounted in the cowl,
locate bulb socket on backside of light and turn bulb
socket a quarter turn counterclockwise to unlock and pull
out bulb and socket. Insert new bulb and rotate socket a
quarter turn clockwise to secure.
Similarly replace the turn signal light bulb, locate bulb socket on backside of light
bar and turn bulb socket a quarter turn counterclockwise to unlock and pull out
bulb and socket. Insert new bulb and rotate socket a quarter turn clockwise to
secure..
To replace the tail and brake light bulb, roll the rubber bezel from around the
edge of the taillight and remove lens. Install replacement bulb and replace
lens.
Fuse Replacement
To replace fuses, locate the fuse block under the driver side seat. Pull out old
fuse and replace with a new automotive type fuse. Headlight and taillight bulbs
and fuses are available from a local Distributor, an authorized Branch or the
Service Parts Department.
Vehicle With A Discharged Battery
To reduce the possibility of severe injury or death from inadvertent motion, do not attempt to
‘jump start’ a vehicle.
The vehicle is equipped with a starter/generator and does not idle. When starting the engine, the starter/generator
functions as a starter and with the engine running, it functions as a generator.
With the short running times associated with this kind of vehicle, the generator is more than adequate to maintain the
battery charge level. The generator is not designed to charge a discharged battery.
When engine starts, the clutches engage and cause vehicle to move making ‘jump starting’ both dangerous and
impractical.
If the vehicle battery has become discharged, it must be charged using a 12 volt charger that is rated at 10 amps or
less. Read and understand all instructions provided by the manufacturer of the charger.
Inside
of Cowl
Headlight
Bulb
Headlight
Casing
Screw