E-Z-GO Terrain 250 - Gas Owner Manual - Page 58
Adjusting the Belt, Battery Cleaning, severe injury or death
View all E-Z-GO Terrain 250 - Gas manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
MAINTENANCE Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers. Adjusting the Belt Loosen the starter/generator pivot bolt. While holding the lower adjusting nut with a wrench, loosen the upper jam nut with another wrench. Move the lower nut up or down the adjustment bolt until proper belt tension is achieved. Hold the lower nut in place and tighten the upper jam nut against it. Tighten the starter/generator pivot bolt. 5 Battery Cleaning To reduce the possibility of damage to vehicle or floor, neutralize acid before rinsing battery. To reduce the possibility of damage to electrical components while cleaning, do not use a pressure washer. Cleaning should take place per the Periodic Service Schedule. When cleaning the outside of the battery and terminals, first spray with a solution of sodium bicarbonate (baking soda) and water to neutralize any acid deposits before rinsing with clear water. Use of a water hose without first neutralizing any acid, will move acid from the top of the battery to another area of the vehicle or storage facility where it will attack the metal structure or the concrete/asphalt floor. Additionally, a residue will be left on the battery which is conductive and will contribute to the discharge of the battery. To reduce the possibility of battery explosion that could result in severe injury or death, do not use metallic spray wand to clean battery and keep all smoking materials, open flame or sparks away from the battery. 1 quart (1 liter) Clear Water The correct cleaning technique is to spray the top and sides of the battery with a solution of sodium bicarbonate (baking soda) and water. This solution is best applied with a plastic spray bottle. The solution should consist of the 2 teaspoons (10 ml) of sodium bicarbonate (baking soda) and 1 quart (1 liter) clear water as shown. In addition to the battery, special attention should be paid to metal components adjacent to the battery which should also be sprayed with the sodium bicarbonate (baking soda) solution. Allow the solution to sit for at least three minutes; use a soft bristle brush or cloth to wipe the tops of the battery to remove any residue that could contribute to the self discharge of the battery. Rinse the entire area with low pressure clear water. Do not use a pressure washer. 2 Teaspoons (10 ml) Sodium Bicarbonate (Baking Soda) Plastic Spray Bottle 5 - 16