EVGA 132-CK-NF79-A1 User Manual - Page 29
Connecting Serial ATA Cables - rx
View all EVGA 132-CK-NF79-A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
nForce 790i Ultra SLI Motherboard Connecting Serial ATA Cables The Serial ATA II connector is used to connect the Serial ATA II device to the motherboard. These connectors support the thin Serial ATA II cables for primary storage devices. The current Serial ATA II interface allows up to 300MB/s data transfer rate. There are six serial ATA connectors on the motherboard that support RAID 0, RAID 1, RAID 5, RAID 0+1 and JBOD configurations. SATA 3 SATA 4 SATA 6 SATA 5 SATA 1 (bottom) SATA 2 (top) GND GND GND TX+ RX+ TX- TX- Connect the locking cable end to the motherboard connector. Connect the end without the lock to the drive. EVGA Corporation 18 January 11, 2008 | DU-03751-001_v01
nForce 790i Ultra SLI Motherboard
EVGA Corporation
18
January 11, 2008
|
DU-03751-001_v01
Connecting Serial ATA Cables
The Serial ATA II connector is used to connect the Serial ATA II device to
the motherboard. These connectors support the thin Serial ATA II cables
for primary storage devices. The current Serial ATA II interface allows up
to 300MB/s data transfer rate.
There are six serial ATA connectors on the motherboard that support
RAID 0, RAID 1, RAID 5, RAID 0+1 and JBOD configurations.
SATA 3
SATA 4
SATA 6
SATA 5
GND
GND
GND
TX+
RX+
TX-
TX-
SATA 1 (bottom)
SATA 2 (top)
Connect the locking cable end to the motherboard connector.
Connect the end without the lock to the drive.