EVGA GeForce GTX 580 FTW Hydro Copper 2 Installation Guide - Page 4

6) Install the provided barbs and stop-fittings. Hose clamps are provided to properly secure tubes to the provided barbs. To properly position the barbs and stop fittings, follow the diagram below: 7 I "I, I I I II This concludes the installation process, the EVGA GTX 580/570 Waterblock is now ready to be used. Important Information EVGA Hydro Copper Waterblocks are leak tested at the factory before shipping to the customer, however, it is still recommended to run a full leak test after mounting of the EVGA Hydro Copper Waterblock has been completed and is fully installed into your water loop. The EVGA Hydro Copper Waterblock is exclusive only to the GTX 580/570 graphics card and was not designed to fit on any other graphics card. It is recommended to use distilled water or any other popular, certified, and approved liquid coolant. Using tap water or any other liquid not meant for water cooling will cause damage such as corrosion to the EVGA Hydro Copper Waterblock. Such damage will void the limited 1 year warranty. It is strongly recommended to not use any aluminum components within the same loop as the EVGA Hydro Copper Waterblock. Mixing copper and aluminum can cause corrosion and any corrosion will void the limited 1 year warranty. Refer to your GTX 580/570 manufacturer's warranty information before installing the EVGA Hydro Copper Waterblock. Should you damage your GTX 580/570 during the installation process, EVGA will not be held liable for the physical damage of your GTX 580/570. 3V 3A Intelligent Innovation 3.