EdgeStar AP13000W Owner's Manual - Page 13

Dehumidifying Mode Sleep Mode Automatic Mode Whether your desired temperature can actually be reached depends on the ambient conditions. The room temperature remaining above the set temperature is normal. To activate this function mode, press the mode button until the cooling symbol appears on the displays. When the cooling mode is set the compressor will start in approximately three minutes. Set the thermostat by using the Up and Down buttons. The thermostat is adjustable between 61°F - 86°F in one degree increments. You can switch between Fahrenheit and Celsius by pressing the ºC / ºF Button. During the Dehumidifying mode, the unit will condense water out of the air and exhaust it through the exhaust hose. The ambient temperature in the room will probably drop by a few degrees while using the Dehumidifying mode. To activate the Dehumidify Mode, press the mode button until the dehumidifying symbol appears on the displays. Please note when changing modes there is an approximate three minute transition time. During the Sleep Mode, the air conditioner gradually increases the set temperature in cooling mode, decreases the noise level and conserves energy. In Sleep mode the temperature is maintained for one hour. In the next 2 hours the temperature is gradually increased by 1°F per hour. After the second hour the temperature remains the same. To activate the Sleep Mode, press the sleep button (moon) until the Sleep symbol appears on the displays. The fan speed is set to low and cannot be altered. At any time you can cancel by pressing the sleep button (moon) on your remote control. In this mode, the air condition is set to run at the optimum comfortable temperature. When the automatic mode is selected the cooling function stops when the temperature is below 74°F. The cooling function and low fan speed starts when the temperature is between 74°F - 78°F Cooling function and medium fan speed starts when the temperature is between 78°F - 81°F. Cooling function and high fan speed starts when temperature is above 81°F. To activate the function mode, press the MODE button on the remote control until the Automatic appears. symbol EdgeStar Portable Air Conditioner 10