EdgeStar CWR262DZ Owner's Manual - Page 12
Using the Temperature Control Panel - not cooling
View all EdgeStar CWR262DZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
OPERATION Using the Temperature Control Panel Run Light Temp. Buttons Light Button Power Button RUN CF Celsius and Fahrenheit Lights Note: Whether your wine cooler can reach the actual set temperature depends on the ambient environmental conditions. Upper Zone Display Lower Zone Display Use the up button to adjust the upper zone's temperature, and use the down button to adjust the lower zone's temperature. The temperature displayed can be in Fahrenheit or Celsius. This wine cooler has a temperature range from 40°F to 54°F for the lower zone, and 54°F to 64°F for the upper zone. This wine cooler has two displays, an Upper Zone Display that shows the temperature in the top section, and a Lower Zone Display that shows the temperature in the bottom section. Press the button on the control panel to adjust the temperature in the upper zone. The button will scroll the temperature by one degree increments. Once you see the desired temperature, stop pressing the button. Note: While pressing the button, it is normal for the temperature to descend, and then jump to the highest available range. After about 5 seconds, the set temperature will revert to the current temperature. Press the button on the control panel to adjust the temperature in the lower zone. The button will scroll the temperature by one degree increments. Once you see the desired temperature, stop pressing the button. Note: While pressing the button, it is normal for the temperature to descend, and then jump to the highest available range. After about 5 seconds, the set temperature will revert to the current temperature. Allow at least 24 hours before storing your wines and to allow the temperature to acclimate. Caution: If you powered off the unit, please wait at least 5 minutes before powering it back on. Press the button to turn the inner light on or off. Press and hold the power button for approximately 3 seconds to turn the unit's power on or off. The Run Light will illuminate when the unit is cooling. The Celsius or Fahrenheit light will be lit depending on what scale temperature is being displayed. To switch between C and F, press and hold the and buttons at the same time for approximately 5 seconds until the temperature scale changes. 9