EdgeStar IF80SS Owner's Manual - Page 7

IMPORTANT: Discard the first batch of ice produced by the portable ice maker. CAUTION: Direct sunlight may cause the ice full infrared sensor to malfunction. If the unit continues to produce ice even though the basket is full, you may need to move the unit away from the sunlight. Operation Using Your Ice Maker Before using your ice maker it is strongly recommended to clean it thoroughly. Read and follow the Cleaning and Maintenance section of the manual before proceeding. Follow the steps below to start using your ice maker. 1. Open the door and remove any packaging tape that may be holding down the ice case, ice shovel, and ice scoop. Remove the ice scoop. 2. Clean the ice storage container. 3. Connect the direct water line into the water inlet valve. 4. Close the door lid. 7. Plug the ice maker's power plug in to a grounded outlet. 8. Press the On/Off power switch Control Panel. 9. Your ice will be created and fill the ice storage container. Notes: If the water pump is unable to detect or pump water, the unit will stop automatically, and the "Add Water" indicator will be lit. Add water to the unit and restart the unit by pressing the On/Off button twice. The ice maker will continue making ice until the ice basket is full. When the ice basket is full "Ice Full" indicator will be lit Using the Control Panel Power Switch Indicator Lights Switch POWER Function Powers the unit on or off Indicator RUN FAULT ICE FULL WATER LOW Function Ice Production is in process. The ice full light will turn on if the ice basket is full. The water low will turn on if the unit does not have enough water in the reservoir. Edgestar Portable Ice Maker 4