EdgeStar KC2000TWINKOM Owner s Manual - Page 8

Note: A detailed installation guide of all the dispense kit components may be included with your kegerator depending on the type purchased. It is recommended that a separate circuit, serving only your kegerator, be provided. Use receptacles that cannot be turned off by a switch or pull chain. The fuse (or circuit breaker) size should be 15 Amps. Recommended grounding method For your personal safety, this appliance's plug must be grounded. It is equipped with a 3-prong power supply cord. To minimize possible shock hazard, the cord must be plugged into a mating 3-prong wall socket and grounded in accordance with the National Electrical Code as well as local codes and ordinances. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electrical current. • Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under any circumstances, cut or remove the third (ground) prong from the power cord. • Any questions concerning power and/or grounding should be directed toward a certified electrician. • This appliance requires a standard 110~120 volt, 60Hz electrical outlet with three-prong ground. • Do not use outlet adaptors. No other appliance should be plugged into the same outlet. Be sure that the plug is fully inserted into the outlet. Leveling the Kegerator It is important for the kegerator to be leveled for optimum efficiency. It can be raised or lowered by rotating the plastic sheaths around each of the feet on the bottom of the machine. If you find that the surface is not level, rotate the feet until the kegerator becomes level. You may need to make several adjustments to level it. 1. If available, place a carpenter's level on top of the product to see if the kegerator is level from front to back and side to side. 2. To adjust the height of the kegerator, simply turn the feet (Right = Lower / Left = Raise) IMPORTANT: Kegerator should be level before installation Installing the Guardrail Snap the guardrail into the top of the cabinet's guardrail pilot holes. Installing the Co2 Cylinder Holder Slide the Co2 cylinder holder onto the four pegs located on the back of the cabinet. This holder is optional and only needed if you plan to have the Co2 cylinder installed externally. 5