EdgeStar PAC8000S Owner's Manual - Page 14

LCD Display Mode Indicator Light Power Button Water Full Light Remote Control Sensor Using the Control Panel The LCD Display will show the ambient temperature by default. Pressing the Up and Down buttons on the remote control will show the set temperature for 15 seconds, and then revert to the room temperature. You can switch between Fahrenheit and Celsius by pressing the C/F button on the remote control. The displayed range of the ambient temperature is from 0º to 99º. Temperatures above 99º will be displayed as "Hi", and temperatures below 0º will be displayed as "Lo". If you enabled the Timer, the LCD Display will show the hour(s) set. The Mode indicator light on the control panel changes color to indicate the mode you selected with the remote control: • Blue light: The unit is in cooling mode. • Amber light: The unit is in dehumidifying mode. • Green light: The unit is in fan mode. Use the Power button to turn the portable air conditioner on and off. By default when you first use the power button, the unit will begin to operate in cooling mode. The unit will remember the last used mode/settings if you shut down and restart. Auto-Restart: If power to the unit is interrupted, the air conditioner will restart itself in its last used mode/settings once power is restored. The compressor will restart after 3 minutes. In high humidity situations, the internal water reservoir may fill. The unit will automatically shut off and the water light will turn on. Once the water is manually drained, the unit will operate normally. The remote control sensor receives infrared signals given by the remote control. 11