Edimax ES-3305P V2 Quick Install Guide - Page 6

TROUBLESHOOTING 1. Power LED is not lit Check if the power cord is properly connected to the external power adapter and the power source. Make sure the DC power jack is firmly plugged into the power socket of the switch. 2. Link/Activity is not lit when connected to devices - Ensure that the network device attached to the switch is switched on. - Check the network cable; ensure it is properly connected to the switch and the network device. - Check the network cable; ensure the UTP cable complied with EIA/TIA 568 and Category 5 specifications. [!] Contact your dealer if problems persist. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class A/B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio technician for help. FCC Caution This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment. CE Mark Warning This is a class B product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. 6