Electrolux E30EW75GPS Owners Guide - Page 8

Oven Rack Supports & Oven Vents

Get Electrolux E30EW75GPS - Icon 30inch Professional Series Single Electric Wall Oven PDF manuals and user guides
UPC - 057112096322
View all Electrolux E30EW75GPS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

8 Feature Overview OVEN RACK SUPPORTS & OVEN VENTS Oven Vent Location The oven is vented under upper control panel for the upper oven and between the doors for the lower oven. When the oven is on, warm air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. Oven Vent Warm Air Installing Oven Rack Supports ALWAYS INSTALL OVEN RACK SUPPORT BEFORE TURNING ON THE OVEN (WHEN THE OVEN IS COOL). To install oven rack support, insert the supports by pushing them downward into the two brackets on each side of the oven interior, as shown below. To remove the oven rack support for a self-clean cycle, pull up the support to disengage them from the brackets. If the rack supports are not removed, the self-clean cycle won't start. Removing and Replacing Extendable Oven Racks ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven. To remove an oven rack, pull the rack forward. Lift up the rack off the oven rack slider. To install an oven rack, locate the two pinholes in the small plates at the front corners of the rack. Place the rack on the side sliders and drop the pin holes over the pins on the sliders. Installed on sliders To remove from sliders Pull oven rack forward and lift it up off the oven rack slider. To place on sliders Do not try to install the extendable oven racks into the standard oven rack levels (or rack support). Installing Standard Oven Rack ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO OPERATING THE OVEN). Always use oven mitts when using the oven. To install, take standard oven rack with the handle in front of you and the stoppers looking down. Align the rear of the rack on the level you want to install it, then push on the rack to slide it in the level until it stops. Must point upward BACK FRONT This stopper will prevent the rack to bump on the convection fan cover at the end of its course. This "safety stopper" will stop the rack when you pull it out. This will prevent you to accidentally pull the rack too far and make it fall. Do not try to install the standard oven rack on the sliders.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
8
Feature Overview
OVEN RACK SUPPORTS & OVEN VENTS
Removing and Replacing
Extendable Oven Racks
ALWAYS
ARRANGE OVEN RACKS WHEN THE
OVEN IS COOL (PRIOR TO
OPERATING THE OVEN).
Always use
oven mitts when using the oven.
To remove an oven rack
, pull the rack
forward. Lift up the rack off the oven rack
slider.
To install an oven rack
, locate
the two pinholes in the small plates at
the front corners of the rack. Place the
rack on the side sliders and drop the pin
holes over the pins on the sliders.
Oven Vent Location
The oven is vented
under
upper control panel
for
the upper oven and
between the doors
for the
lower oven. When the oven
is on, warm air is released
through the vent. This
venting is necessary for
proper air circulation in the
oven and good baking
results.
Installing Oven Rack Supports
ALWAYS INSTALL OVEN RACK
SUPPORT BEFORE TURNING ON
THE OVEN (WHEN THE OVEN IS
COOL).
To install oven rack support
, insert
the supports by pushing them downward
into the two brackets on each side of
the oven interior, as shown below.
To remove the oven rack support
for
a self-clean cycle, pull up the support to
disengage them from the brackets. If
the rack supports are not removed, the
self-clean cycle won’t start.
Installed on sliders
To remove from
sliders
To place on sliders
Pull oven rack forward and lift
it up off the oven rack slider.
Oven Vent
Warm Air
Do not try to install the extendable oven racks
into the standard oven rack levels (or rack support).
Installing Standard Oven Rack
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO
OPERATING THE OVEN).
Always use oven mitts when using the oven.
To install, take standard oven rack with the handle in front of you and the stoppers looking down. Align the rear of the
rack on the level you want to install it, then push on the rack to slide it in the level until it stops.
This stopper will prevent the rack to bump on
the convection fan cover at the end of its course.
This “safety stopper” will stop the rack when you pull it out.
This will prevent you to accidentally pull the rack too far and
make it fall.
Must point
upward
Do not try to install the standard oven rack on the sliders.
FRONT
BACK