Electrolux E30WD75GTT Installation Instructions - Page 2
Important Safety, Instructions - parts
View all Electrolux E30WD75GTT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing appliance. 2. Remove all packing material from appliance before connecting the electrical supply. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. Important Note to the Consumer Keep these instructions for future reference. IMPORTANT SAFETY INSTRUCTIONS • Be sure your appliance is installed and plugged into a 120 Volt grounded outlet. • This appliance must be electrically grounded in accordance with the National Electrical Code ANSI/ NFPA No. 70-latest edition in the United States, or CSA C22.1, Part 1 in Canada, and local code requirements. 2.Slide drawer into cutout opening until front frame of drawer is flush against cabinet. Be careful not to pinch electrical cord. 3.Remove the drawer as instructed in the Use & Care Guide and secure drawer housing to cabinet using the 3 nickel-plated screws supplied (see Figure 2). Do not overtighten screws. 4.The 60" (152,4 cm) appliance power cord can now be connected into the 120 Volt outlet. 5.Proceed with mounting built-in oven above the drawer (if applicable). Follow installation instructions provided with built-in oven. Make sure to use anti-tip brackets supplied with the built-in oven. Tools You Will Need Phillips® Screwdriver Pencil Ruler or Tape Measure and Straight-edge Hand Saw or Saber Saw Spirit Level Use screws supplied to attach drawer to front of cabinet. Figure 2 Warm & Serve Drawer Installation 1.Locate the 2 anti-tip brackets supplied as shown on fig. 1. c/c 25 5/16" (64,3 cm) c/c 12 21/32" (32,15 cm) 24" (61 cm) Max. 23 5/8" (60 cm) Min. Figure 1 2