Electrolux EDW7505HSS Complete Owner's Guide (English) - Page 21

Solutions to Common Problems 21 DISHWASHER HAS AN ODOR ERROR CODES • Soiled dishes left in dishwasher too long can create an odor. Use Rinse cycle. • There will be a "new" smell when first installed. This is normal. • Check to see if unit is draining properly (See Dishwasher Does Not Drain Properly, page 20). REMOVING SPOTS AND FILM Hard water can cause lime deposit build-up on the interior of the dishwasher. Dishes and glasses may also get spots and film for a number of reasons (See Glassware/Flatware Spotted or Cloudy, page 19). To remove build-up, spots and film, clean using the following instructions: 1 Load clean dishes and glasses in normal manner. Do not load any metal utensils or silverware. 2 Do not add detergent. 3 Select the NORMAL WASH cycle. Press START/CANCEL pad and close door. 4 Allow dishwasher to run until it begins the second fill. Open door and pour 2 cups of white vinegar into the bottom of dishwasher. 5 Close and latch door and allow cycle to finish. NOTE If these conditions persist, a home water softener should be considered. In certain situations which are critical to the machines function and safe operations. Er 01 Leak Detector - When water is detected under the tub. Er 02 Thermistor - When thermistor/turbidity module fails Er 03 Wash Pump - Wash pump not operating Er 04 Drying Damper - Drying damper not operating Er 05 Upper Fan - When in the dry cycle, the control board does not receive proper speed feedback from the upper fan Er 06 Lower Fan - When in the dry cycle, the control board does not receive proper speed feedback from the lower fan Er 07 Drain Valve - When in the drain mode, the control board does not receive proper position feedback from the drain valve Er 08 Tactile or touch switch - Control board has verified a switch on the user interface is bad or shorted Er 09 Communications - Communication failure between main user board and power supply Er 10 Mains Relay - Failure in the mains power relay Er 11 Drain Valve - Time out before finding a state for the drain valve Er 12 Drain Valve - The drain valve is running when it should be off Er 13 System wide - Lost control of the State Machine