Electrolux EFLW317TIW Complete Owner s Guide English - Page 16
Other Features
View all Electrolux EFLW317TIW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
16 Operating Instructions Other Features Chime (press & hold set button) A signal will sound at the end of the cycle (and periodically during extended refresh) if this option is activated. time (0 min) for 60 seconds and then repeat. Acknowledge the reversed hose condition by pressing the cancel button. Shut off each water supply valve and attach each supply hose to the correct inlet connection on the washer. (60 sec loop) Muting the end of cycle signal will not mute the button tones. Eco Indicator The " " symbol will light up on the center display to indicate that your selected combination of temperature, spin speed and options are eco friendly. Status Display The estimated total cycle time will be displayed when the cycle is selected. The time may increase if water pressure is low, oversudsing occurs or the load becomes unbalanced. The approximate time remaining will be displayed during the cycle. As the washer progresses through the cycle phases, the row of cycle phase indicators lights up under the cycle time. Drum Light (on select models) The drum light will come on whenever the door is opened to illuminate the drum during loading and unloading. Closing the door turns off the light. The drum light will automatically turn off if the door is left open more than 3 minutes. Reversible Door (on select models) Your washer may be equipped with a reversible door. The door can be hinged on the right or left side. NOTE For step-by-step instructions on door reversal, refer to the Installation Instructions supplied with this washer. Door Stand Ventilation Help prevent odor buildup and reduce humidity between washes by utilizing your washer's door stand ventilation feature. Open the door, locate the stand below the door latch and rotate the stand counter-clockwise to unlock it. NOTE If you are unable to rotate the stand with fingers, you can use a coin or flat blade screw driver. Oversuds Protection A situation where oversudsing has been detected by the washer will result in the washer requiring additional rinses until the suds have been cleared. Each extra rinse the washer performs to clear the suds will add approximately 5 minutes to the cycle duration. The L.E.D. will display "SU" followed by "dS" and then the remaining cycle time (0 min) for 60 seconds and then repeat. Acknowledge the oversuds condition by pressing the cancel button. The stand is spring loaded and will extend. Rotate it clockwise to lock in the extended position. 2 1 3 (60 sec loop) Reversed Hose Detection If condition is detected where the inlet hoses have been installed incorrectly (hot supply to cold inlet and cold supply to hot inlet), the washer will alert you. The L.E.D. will display "HO" followed by "SE" and then the remaining cycle To disengage the stand, rotate to unlock, push the stand in and rotate to lock position. NOTE If door stand will not turn to locked position, fully turn it to unlock position and try to lock again.